ISAFE MOBILE EXECUTIVE 2.0 Operator's manual

Quick Start Manual
and
Safety Instrucons
i.safe MOBILE
EXECUTIVE 2.0

i.safe MOBILE
EXECUTIVE 2.0
Index
English ................................................ page 03
Deutsch ................................................ page 09
Français ................................................ page 16
Italiano ................................................ page 23
Nederlands............................................... page 29
Polski ................................................ page 36
Magyar ................................................ page 43
Suomi ................................................ page 49

Document No. 1010DI02REV01
Version: 2015-02-05
(c) 2015 i.safe MOBILE GmbH
i.safe MOBILE GmbH
i_Park Tauberfranken 10
97922 Lauda-Koenigshofen
Germany
Tel. [phone]
[e-mail]
www.isafe-mobile.com
i.safe MOBILE
English
2

i.safe MOBILE
English
3
1 Quick Start Manuel and Safety Instrucons
This document contains informaon and safety regulaons which are to be ob-
served without fail for safe operaon of the mobile phone EXECUTIVE 2.x under
the described condions. Non-observance of this informaon and instrucons
can have serious consequences and / or may violate regulaons.
More detailed instrucons on the use of the phone can be found at www.isa-
fe-MOBILE.com or directly at i.safe MOBILE GmbH.
Please read the manual and these safety instrucons before using the phone.
In case of contradicng informaon, the text of these safety instrucons shall
apply. In case of any doubt, the German version shall apply.
The EC declaraon of conformity can be found at the end of this document.
EC and IECEx cercates of conformity, safety instrucons and manuals can be
found at www.isafe-mobile.com, or requested from i.safe MOBILE GmbH.
Reservaon: Technical Data is subject to change without noce. Changes, errors
and misprints may not be used as a basis for any claim for damages. All rights
reserved.
i.safe MOBILE GmbH cannot be held responsible for any data or other loss and
direct or indirect damages caused by any improper use of this phone.
2 Ex-Specicaons
The EXECUTIVE 2.x is a mobile phone suitable for use in potenally explosive
atmospheres classied as Zone 2 in accordance with direcves 94/9/EC (ATEX
95) and 99/92/EC (ATEX 137).
Ex-markings
ATEX II 3G Ex ic IIC T4 Gc
EPS 14 ATEX 1 774 X
2004
Temperature range: -20 ... +60°C
Manufactured by: i.safe MOBILE GmbH
i_Park Tauberfranken10
97922 Lauda-Koenigshofen
Germany
3 EC Declaraon of Conformity
The EC declaraon can be found at the end of this manual.

i.safe MOBILE
English
4
4 Faults and Damages
If there is any reason to suspect that the safety of the phone has been com-
promised, it must be withdrawn from use and removed from any ex-hazardous
areas immediately.
Measures must be taken to prevent any accidental restarng of the phone.
The safety of the phone may be compromised, if, for example:
• malfuncons occur.
• the housing of the phone or the baery shows damage.
• the phone has been subjected to excessive loads.
• the phone has been stored improperly.
• markings or labels on the phone are illegible.
It is recommended that a phone which shows or which is suspected of faults
and damages is returned i.safe MOBILE GmbH for inspecon.
5 Ex-relevant Safety Regulaons
Use of this phone assumes that the operator observes the convenonal saf-
ety regulaons and has read and understood manual, safety instrucons and
cercate.
The following safety regulaons must also be complied with:
• Inside ex-hazardous areas the phone must be closed. The baery cover has
to be xed by the two screws and the covers of the interfaces have to be
closed.
• To ensure the IP-protecon, it has to be ensured that all gaskets are present
and funconal. The screws at the top and the boom of the back of the pho-
ne need to be covered by the black gaskets, so that the screw heads are not
visible. There must be no large gap between the two halves of the housing.
• The baery may only be exchanged or charged outside ex-hazardous areas.
• The phone may only be charged outside ex-hazardous areas using the appro-
priate charger or other equipment approved by i.safe MOBILE GmbH.
• Use only the appropriate baery type BPE02A or BPE02B.
• It is not allowed to carry spare baeries into ex-hazardous areas.
• The phone may be charged only at temperatures in between 0°C ... 45°C.
• The phone must not be exposed to abrasive acids or bases.
• The phone must not be taken into zones 0, 1, 20, 21 or 22.
• Only accessories approved by i.safe MOBILE GmbH may be used.

i.safe MOBILE
English
5
6 Further Safety Advises
• Do not touch the screen of the phone with sharp objects. Dust parcles and
nails may scratch the screen. Please maintain the screen clean. Re-move dust
on the screen with a so cloth gently, and do not scratch the screen.
• Charge the phone under indoor condions only.
• Do not put the phone in environments with excessive temperatures, as this
could lead to heang of the baery, resulng in re or explosion.
• Do not charge the phone near any ammable or explosive substances.
• Do not charge the phone in environments with much dust, humidity, or
excessively high or low temperatures (the permied charging tempera-ture
range is 0 ... 45°C).
• Do not use the phone in areas where regulaons or legislaves prohibit the
use of a mobile phone.
• Do not expose the phone, baery or charger to strong magnec elds, such
as are emied from inducon ovens or micro-waves.
• Do not aempt to open or repair the phone. Improper repair or opening
can lead to the destrucon of the phone, re or explosion. Only author-ized
personnel are allowed to repair the phone.
• Only use accessories approved by i.safe MOBILE GmbH.
• Please do not directly connect the poles of the baery, to avoid short-circui-
ng the baery.
• Power o the phone in hospitals or other places where the use of mobile
phones is prohibited. This phone may aect proper work of medical equip-
ment, such as pacemakers, so always keep a distance of at least 15 cm bet-
ween the phone and these devices.
• Observe all corresponding laws that are in force in the respecve coun-tries
regarding the use of mobile phones while operang a vehicle.
• Please power o the phone and disconnect the charging cable before clea-
ning the phone.
• Do not use any chemical cleaning agents to clean the phone or the charger.
Use a damp and an-stac so cloth for cleaning.
• Do not discard old and abandoned lithium baeries into the trash, send
them to designated waste disposal locaons or return them to i.safe MOBILE
GmbH.
• The user alone is responsible for any and all damages and liabilies caused
by malware downloaded when using the network or other data-exchange
funcons of the phone. i.safe MOBILE GmbH cannot be held responsible for
any of those claims.

i.safe MOBILE
English
6
Warning
i.safe MOBILE GmbH will not assume any liability for damages caused by disre-
garding any of these advices or by any inappropriate use of the phone.
7 Maintenance / Repair
Thank you for using the EXECUTIVE 2.x. If there is a problem with the phone,
please contact your vendor or consult the service center. If your phone is in
need of repair, you can either contact the service center or your vendor.
8 Baery
The baery is inserted into the back of the phone. The baery is not fully char-
ged when the phone is purchased, but it contains enough energy to power on
the phone. To obtain best baery performance and baery life, let the baery
discharge completely before charging it completely for the rst three charging
cycles.
8.1 Installing the Baery
Turn the mobile phone upside down, open the screws and remove the baery
cover. Install the baery by inserng the teeth at the top of the baery into the
corresponding notches of the phone.
When installing the baery cover, insert the teeth at the boom of the cover
into the corresponding notches of the mobile phone, then press the baery
cover down and secure it by turning the two screws. Ensure that the baery is
safely in place before installing the baery cover and powering on the phone.
8.2 Charging the Baery
Connect the USB-cable with the USB connector at the boom of the phone.
Connect the other side of the USB cable with the socket of the Power Supply.
Aer charging, remove the USB-cable from the charger.
8.3 Baery Use
In actual use, the standby me and talk me of the phone varies with the net-
work status, working environment and usage.
When the power of the baery is lower than normal, the phone will prompt you
to charge it. Please charge the baery; otherwise you may lose any les which
are not saved. If you do not charge for a long me, the phone will be powered
o automacally.
Warning
The phone may only be charged at ambient temperatures in a range from
0°C…45°C. Please do not use charging equipment if the temperature exceeds
this range.

i.safe MOBILE
English
7
9 Installaon of the SIM Cards
The phone features two SIM card slots. The slots are accessible aer removal
of the baery. If you have installed two SIM cards, you can choose your primary
card in <Sengs> → <SIM management> .
Warning
Do not try to insert or remove any of the SIM cards when any external power
supply is connected, otherwise the SIM cards or the phone may be damaged.
10 Installaon of the Micro-SD Card
The slot for the Micro-SD card is accessible aer removal of the baery. Open
the Micro-SD card holder, and insert the Micro-SD card into the slot, then close
the Micro-SD card holder.
11 Powering On Your Phone
Press the [Power key] unl the screen lights up. Depending on the security set-
ngs of your SIM card, the phone may ask you for your personal idencaon
number (PIN) before starng up.
The rst me you power on your phone, you may be prompted to assign a lan-
guage, date and me zone and enter your personal informaon. You will also be
asked to sign in or set up your Google account. You can do this later but please
note that some of the funcons of the phone like the Google Play Store depend
on a Google account.
12 Keys and Special Features
(see gure on page 2)
(1) Power: Lock the phone. Long press to power up or down the
phone.
(2) Menu: Bring up a list of opons.
(3) Home: Returns to the Home Screen. Long press to see a list
of last accessed apps.
(4) Back: Return to the previous screen.
(5) Volume: Context-sensive volume regulaon.
(6) SOS: Long press to acvate the SOS-alert (oponal).
(7) PTT: Acvate the Push-to-Talk funcon (oponal).
(8) Baery: Use these screws to open the baery compartment.
(9) Camera: Not installed in EXECUTIVE 2.1.
(10) USB: USB connector for charging and data-transfer.

i.safe MOBILE
English
8
13 Security Sengs
To change security relevant sengs, the phone may ask for a password. The
standard password is 1122.
14 Recycling
The crossed-out wheeled-bin symbol on your product, baery, literature, or
packaging reminds you that all electrical and electronic products, baeries, and
accumulators must be taken to separate collecon at the end of their working
life. This requirement applies in the European Union. Do not dispose of these
products as unsorted municipal waste.
Always return your used electronic products, baeries, and packaging materials
to dedicated collecon points. This way you help prevent uncontrolled waste
disposal and promote the recycling of materials.
More detailed informaon is available from the product retailer, local waste
authories, naonal producer responsibility organisaons, or your local i.safe
MOBILE GmbH representave.
The content of this document is presented as it currently exists. i.safe MOBILE
GmbH does not provide any explicit or tacit guarantee for the accuracy or
completeness of the content of this document, including, but not restricted to,
the tacit guarantee of market suitability or tness for a specic purpose unless
applicable laws or court decisions make liability mandatory. i.safe MOBILE
GmbH reserves the right to make changes to this document or to withdraw it
any me without prior noce.

i.safe MOBILE
Deutsch
9
1 Schnellstartanleitung und Sicherheitshinweise
Dieses Dokument enthält Informaonen und Sicherheitsvorschrien die für
einen sicheren Betrieb des Mobiltelefons EXECUTIVE 2.x unter den beschrie-
benen Bedingungen unbedingt zu berücksichgen sind. Nichtbeachtung dieser
Informaonen und Anweisungen kann gefährliche Folgen haben oder gegen
Vorschrien verstoßen.
Lesen Sie die Bedienungsanleitung und diese Sicherheitshinweise bevor Sie das
Telefon benutzen! Im Falle widersprüchlicher Informaonen gelten die deut-
schen Anweisungen in diesen Sicherheitshinweisen.
Die gülge EG-Konformitätserklärung, EG und IECEx Baumusterprüescheini-
gung, Sicherheitshinweise und Bedienungsanleitung können unter www.isa-
fe-mobile.com heruntergeladen oder bei der i.safe MOBILE GmbH angefordert
werden.
Vorbehalt: Technische Änderungen behalten wir uns vor. Änderungen, Irrtümer
und Druckfehler begründen keinen Anspruch auf Schadensersatz. Alle Rechte
vorbehalten.
Für Datenverluste oder andere Schäden gleich welcher Art, die durch den un-
sachgemäßen Gebrauch des Mobiltelefons entstanden sind, übernimmt die
i.safe MOBILE GmbH keine Haung.
2 Ex-Spezikaonen
Das Mobiltelefon EXECUTIVE 2.x ist geeignet für den industriellen Einsatz in ex-
plosionsgefährdeten Bereichen der Zone 2 nach Richtlinien 94/9/EG (ATEX 95)
und 99/92/EG (ATEX 137) und dem IECEx-System.
Ex-Kennzeichnungen
ATEX II 3G Ex ic IIC T4 Gc
EPS 14 ATEX 1 774 X
2004
Temperaturbereich: -20 ... +60°C
Hersteller: i.safe MOBILE GmbH
i_Park Tauberfranken10
97922 Lauda-Koenigshofen
Germany
3 EG Konformitätserklärung
Die EG Konformitätserklärung bendet sich am Ende dieser Anleitung.