iSens NoCoding1 Plus User manual

©2018 i-SENS, Inc. All Rights Reserved PGK8E3040 REV2 01/2018
i-SENS, Inc.
43, Banpo-daero 28-gil,
Seocho-gu, Seoul 06646, Korea
www.i-sens.com
Medical Technology Promedt
Consulting GmbH
Altenhofstrasse 80,
66386 St.Ingbert, Germany
Owner’s Booklet

Thank you for choosing the NoCoding1 Plus Blood Glucose
Monitoring System. The system provides you with safe, fast, and
convenient blood glucose in vitro (i.e., outside the body)
diagnostic monitoring. You can obtain accurate results
in just 5 seconds with a small (0.5 µL) blood sample.
Welcome to the NoCoding1 Plus
Blood Glucose Monitoring System
• No part of this document may be reproduced in any form or by any
means without the prior written consent of i-SENS.
• The information in this manual is correct at the time of printing.
However, i-SENS reserves the right to make any necessary changes at any
time without notice as our policy is one of continuous improvement.

2.0-3.8 mmol/L
Situations Do This
• When the control solution bottle was
not shaken well,
• When the meter, test strip, or the control
solution were exposed to high or low
temperatures,
• When the first drop of the control
solution was not discarded or the tip of
the bottle was not wiped clean,
• When the meter is not functioning
properly.
Repeat the
control solution
test by referring
to the “Notes”
on page 21.
• When the control solution is past the
expiration date printed on the bottle,
• When the control solution is past its
discard date (the date the bottle was
opened plus three (3) months),
• When the control solution is
contaminated.
Discard the used
control solution
and repeat the
test using a new
bottle of control
solution.

www.i-sens.com 35
Things to Know When Using AST
Please read the following before testing at alternate sites
(forearms and palms).
The capillary whole blood at the fingertips reflects changes in
glucose levels more rapidly than in alternate sites. The test results
from the fingertip testing and AST may differ due to factors such
as lifestyle and ingested food which affect glucose levels.
Acceptable Situations for AST
When your blood glucose levels are stable
• Fasting period
• Before a meal
• Before going to bed
Situations Requiring Fingertip test
When your blood glucose levels are unstable
• During two (2) hours after a meal or exercise
• When sick or when glucose levels seem quite lower
than test value
• When hypoglycemia is not well recognised
• When insulin has the biggest effect
• During two (2) hours after an insulin injection

36 www.i-sens.com www.i-sens.com 37
AST Precautions
• Do not ignore the symptoms of hyperglycemia or
hypoglycemia.
• When the results of the test do not reflect your opinion,
retest using the fingertip test. If the fingertip result still does
not reflect the way you feel, please consult your healthcare
professional.
• Do not rely on the AST results for changing your treatment
method.
• The amount of glucose in alternate sites differs from person
to person.
• Before using AST, please consult your healthcare
professional.
Note:
• Results from alternate sites and fingertip samples may
differ from each other as there is a time lag for the glucose
levels to reach the same value. Use a fingertip for testing
if you suffer from hypoglycemia or have experienced
hypoglycemic shock or symptoms.
• If the sample drop of blood runs or spreads due to contact
with hair or with a line in your palm, do not use that sample.
Try puncturing again in a smoother area.
HI and Lo Messages
HI Message
The meter displays results between
20-600 mg/dL (1.1-33.3 mmol/L). 'HI' appears
when the blood glucose level is greater than
600 mg/dL (33.3 mmol/L) and indicates severe
hyperglycemia (much higher than normal glucose
levels).
If 'HI' is displayed again upon retesting, please
contact your healthcare professional immediately.
Lo Message
'Lo' appears when a test result is less than
20 mg/dL (1.1 mmol/L) and indicates severe
hypoglycemia (very low glucose levels).
If 'Lo' is displayed again upon retesting,
please contact your healthcare professional
immediately.
Note: Please contact your authorised i-SENS sales
representative, if such messages are displayed even though
you do not have hyperglycemia or hypoglycemia.