iSinwheel V8 User manual

1. Safety Instructions 01
2. Product Overview 04
3. Battery and Charging 06
4. Electric Skateboard Specification 07
5. Battery & Charger Specifications 08
6. Contact Us 09
Contents

Protect this device from moisture, humidity, water and any other liquid. Avoid using/
storing it in extreme temperatures. Do not expose it to direct sunlight and sources of
heat. Before connecting the device to power supply socket, make sure the voltage
indicated on the appliance corresponds to the voltage in the power supply socket.
Children who are over 13 years old and people with reduced physical, sensory or mental
capabilities, or lack of experience and knowledge, may ride this device if they are
supervised and guided by a person who is responsible for their safety in a cautious
manner, and all the safety precautions are understood and followed. Children should not
play with this device. Children should not perform cleaning and servicing of the device
unsupervised. Device is not suitable for use by persons whose health might be in danger
in case of a possible fall from the device (Children, Elderly,
■ Do not use this device in case of abnormal operation.
Only use authorized accessories.
■ Do not attempt to repair/disassemble this device yourself.
In case of damage, contact with an authorized repair service for check-up/repair.
■ Disconnect this device from power supply before cleaning and service.
■ Do not use this device near flammable products.
■ Do not ride after drinking or taking drugs/medications of any kind or any other
substances which may affect your cognitive or motor skills.
■ When riding this skateboard, you should comply with local laws and regulations
including traffic laws.
■ The skateboard is designed for one person at a time only! It's prohibited for two
persons to ride the skateboard at the same time.
■ Do not lift the skateboard off the ground when it is powered on.
■ Do not power it on in midair.
■ Do not ride this skateboard off of curbs, ramps or attempt to operate in a skate park,
empty pools etc. This device is an electric skateboard and has electronic components
and battery underneath the deck. Performing such actions will lead to damage of the
electrical elements.
■ Do not climb up or down steep hills.
■ Do not jump off or on your skateboard.
Pregnant Women, etc.)
Safety Instructions
01

Before operating this skateboard, read all the instructions and keep it for future
reference. This manual includes useful tips and tricks as well as important safety
information on use and handling of the device. Manufacturer is not responsible or liable
for any damages or injuries caused by inappropriate use or handling of this device.
■ Be sure to apply all appropriate safety measures when operating this device.
■ Wear a helmet, knee pads, elbow pads and other protective gears.
■ Relax your legs while riding, slightly bend your knees. They can help maintain balance
when encountering uneven ground.
■ In the process of driving, ensure that both feet are always on the deck.
Safe Riding
This device is water-resistant and dustproof with an IP54 rating, which prevents intrusion
of solid objects (limited protection against dust ingress) and provides protection from
water splashing against the housing.
IMPORTANT: Water and dust protection rating is not permanent and can decrease over
time as a result of everyday usage of the device. Despite the IP54 rating, the device is
not resistant to damages in certain situations. The warranty does not cover mechanical
nor liquid damages.
Protection Level
Before using the skateboard, make sure the battery is fully charged and all parts of the
device are in good condition.
Note: in case of a tire stall, the device will automatically power off after a few seconds.
Preparation Before Operation
Please note that the device poses restrictions concerning rider’s weight (120 kg / 264 lbs
max). Do not overload the skateboard, as it may lead to damage and injuries.
Weight Limit
Any damage or injury caused by use disregarding the instruction manual falls under
responsibility of the user. Do not perform sudden swerves when riding fast or on a slope,
which is dangerous. Such action can lead to loss of balance and put you at risk.
Warning - Possible Risk of Riding
IP54
02

■ Avoid riding on steep slopes, through potholes or bumps. The weight of the rider and
belongings should not exceed the maximum load indicated in the instruction. Overload
may lead to injuries or damages.
■ Ensure the skateboard speed is safe for you and others.
■ Keep a safe distance from other devices to avoid collisions.
■ Keep in mind that when you are on the skateboard, your height increases. Pay
attention of this while riding through door, narrow space, etc.
■ Do not ride on rainy or snowy days.
■ Do not ride on slippery ground (i.e. snow, ice, wet surfaces).
■ Do not ride on surfaces made of loose fabric or covered in items that could get
in/entangle in the wheels (e.g. thick carpet).
It is recommended to wear comfortable clothing that do not block, limit or restrict move-
ments.
Wear comfortable flat shoes to maintain flexibility and full motion range.
Practice your riding skills on flat and even surface in an open space. Avoid places with
pedestrians and obstacles before you are confident in your driving skills. Make sure
you've mastered getting on the device, accelerating, coming to a stop, and making turns
before you try higher speed.
Pay attention when riding near cables and cords! Slow down when on uneven ground!
Riding Tips
Do not clean the skateboard while charging!
Periodically clean the outside of the skateboard with a soft, slightly damp cloth. Do not
use chemical cleaning agents.
Cleaning
Do not store the skateboard if the skateboard's battery is very low or discharged. Please
charge the battery before storage to prevent the battery from being over-discharged due
to long-term non-use.
If the skateboard is idle, charge your device's battery every three months to maintain
battery life.
Do not wrap or put the skateboard in packaging immediately after charging, as the
battery may become hot during charging - a fire hazard.
Storage
03

Power Switch
Device
Lights
Deck
Rear Wheel / Motor
Battery Compartment
Product Overview
04

1.Make sure the skateboard and the remote are fully charged before operation. Power
on the skateboard and the remote.
2.Step on the deck. Push and hold the accelerator switch slowly to accelerate. Release
the accelerator slowly to slow down. Pull back the switch to stop the device. It works the
same way in both direction modes.
3.Slide the speed switch to adjust speed of the skateboard. It's suggested to use the low
speed mode for beginners.
4. Power off the skateboard and the remote when they are in use. If you don't switch
device off, it will stay on for 10 minutes so that when you step on it again, you can
continue riding without
engaging on / off switch. If not used within that period, it will automatically switch off
after the time period is up.
■ The range of this device depends on many factors, the following factors may shorten
the range: Uneven ground will shorten the range.
■ Weight of the rider.
■ Extreme temperatures. The battery performance decreases quickly in cold conditions.
■ Maintenance. Proper handling, charging, etc. will optimize the range.
■ Distance and speed. Moderate, economic riding speed will optimize distance, while
frequent starts, stops, and speed changes will shorten the range.
Range (Cruise distance on one charge)
Remote
OPERATION
Power Switch
Skateboard
battery indicator
Remote
battery indicator
Acceleration/Brake Switch
Mini USB Charging Port
Reverse
Signal Light
05

■ Always check the battery level before using.
■ Do not ride when its battery level is low! Charge the battery when the battery indicator
signals low level.
■ Do not use the device if the battery gives out any odor, excessive heat or leakage.
■ Do not use the device when the battery is charging!
■ Ensure the charging port is dry before charging!
■ Charge the device only with the included/authorized power adapter.
■ Do not continue riding when the battery level reaches minimum. Otherwise, it will affect
battery's life.
Battery
1. Plug the AC end of charger into mains socket (110V- 240V AC, 50/60 Hz). The
indicator on the charger lights up green.
2. Plug the other end of the charger into the device. The indicator on the charger will turn
red.
3. When the indicator turns from red to green, the charging is complete. Disconnect
charger from device and electrical outlets.
Do not overcharge the device, as it may affect battery life.
Charging
Always check the battery level before using. Do not ride when its battery level is low.
When the battery level of the skateboard is below 10%, it will issue sounds - in such
case, stop, get off, and power off the skateboard!
Warnings:
Battery and Charging
06

V8 Electric Skateboard
Power
Motor
Maximum load
Net weight
Gross weight
Size 36.4*11.8*5.3 IN / 92.5*30*13.5
18.1 LBS / 8.25 KG
24.2 LBS / 11 KG
CM
Top Speed
Maximum endurance
Maximum climbing angle
Protection class
Wheel size
Plate
Wheel material
2 Riding modes (backward)
4 Travel speeds
Remote
Protection
Light
600W*2
Brushless
264LBS/120 KG
28-30 MPH / 45-48 KM/H
10-12 MILES / 16-19 KM
25%
IP54
4.1 IN / 10.5 CM
A
9 Maples
luminum alloy and PU
2 riding modes (backward)
2nd gear: 10-12 MPH max speed
3rd gear: 28-30 MPH max speed
4th gear: 28-30 MPH max speed
1st gear: 6-8 MPH max speed
2.4 GHz
Short circuits and overheating
12V
Electric Skateboard Specification
07

Rechargeable Lithium Polymer Battery
Voltage
Capacity
Operating Temperature
Storage Temperature
Charging Temperature
Relative Storage Humidity
Charging Time
36V
5.2Ah
-15°C~+50°C / 5F°~+120F°
-20°C~+25°C / -5F°~+80F°
0°C~+40°C / 0F°~+100F°
5~95%
(Applies to EU and other European countries with separate collection systems) This
marking displayed on the product or its literature indicates that it should not be disposed
of with other household waste at the end of its useful life. To prevent possible harm to the
environment or human health from uncontrolled waste disposal, please separate it from
other types of waste and recycle it responsibly to promote the sustainable reuse of
material resources. Home users should contact the retailer or local government office
where they purchased this product for details on where and how they can use this item
for environmentally safe recycling. Business users should contact their suppliers and
check the terms and conditions of purchase contracts. This product must not be mixed
2-3 H
with other commercial waste for disposal.
Proper Disposal of This Product
(Waste Electrical and Electronic Equipment)
Charger
Input
Output
Remote Control Nattery
Remote Control Power Supply
110-240 V, 50/60 Hz
42 V; 2,0 A
3,7 V, 200 mAh
5 V DC, 0.5 A
Battery & Charger Specifications
08

Contact us if you experience issues relating to riding, maintenance and safety,
or errors/faults with your isinwheel V8 Electric Skateboard.
E-mail Service: [email protected]
www.isinwheel.com
Facebook: @isinwheelOfficial
YouTube: isinwheelOfficial
Contact Us
09
ins: isinwheel_official