Size and Weight:
The built-in battery specification 80 mAh, 3.6V, NI-MH battery
Solar panel 5.5V, 20mA
Main Technical Parameters
Power
Switch
Working Principle:
This product adopts the principle of cranking for power by three phase alternator and solar - energy for
power generation. The power stored is used to charge the built-in 80 mAh/3.6V Ni-MH chargeable battery
after commutating and filtering as the power source of the LED light.
Functions:
1. Cranking for power generation.
2. Charged in direct sunlight.
3. 1 LED lighting/ 3 LEDs lighting /3LEDs flashing for a circle.
4. Waterproof under 5 meters water.
Features:
1. Low noise and high efficiency.
2. Charged by direct sunlight.
3. Convenient to use, no external batteries.
4. Controlled by electric switch, long life-span.
5. Unique design,novel and fashionable.
6. It can work normally under 5 meters water.
Max. Luminous flux of 3 LEDs 8Lm
Max. Luminous flux of 1 LED 3Lm
Lighting time of 3 LEDs after being charged fully 4 hours
Lighting time of 3 LEDs after 1 minute cranking 60 minutes
Lighting time of 1 LED after 1 minute cranking 80 minutes
Flashing time after 1 minute cranking 110 minutes
Lighting time of 3 LEDs after being charged by direct sunlight for 1 hour 90 minutes
Lighting time of 1 LED after being charged by direct sunlight for 1 hour 120 minutes
Flashing time after being charged by direct sunlight for 1 hour 140 minutes
Fully charged time by sunlight 8 hours
Flash frequency About 2 Hz
Main parts life-span:
LED light 50000 hours
Switch lifetime 100 000 times
The whole unit
lifetime 5 years
Plastic part lifetime 5 years Size of this unit About 147.5*61.5*45mm
Weight of this unit About 176g
Others:
Operation Method:
1. Unlock the handle and crank it at the speed of 3 circles per second for 1 minute, press the switch, the light
will be on.
2. Place the flashlight in the direct sunlight to charge it.
3. Lighting modes: press the switch once, one LED in middle lights up; press again, three LEDs on, press for
the third time, 3 LEDs Flashing, press once more, the flashlight is off.
Cautions:
1. Do not aim at anyone’s eyes in case of hurting the eyes.
2. Crank it as even as possible (keep rotating steadily). Too slowly cranking would make the current weak
and prolong the charging time, and too violent cranking will possibly damage the power transferring system.
3. Pay attention to the holding gesture when cranking, so as not to hurt your fingers and fingernails.
4. To ensure the using life of the inside battery, cranking no more than 3 minutes continuously when the the
flashlight can light normally and less than 10 minutes when it can’t light.
5. Cranking the handle at least 1 minute once a month to prolong the life of product.
Handle
3 LEDs
Solar
Panel
C
r
a
n
k
i
n
g
f
o
r
p
o
w
e
r
WATERPROOF SOLAR/
DYNAMO HAND CRANK
FLASHLIGHT
User Guide
Distributed by C&A Marketing, Inc.
2 Bergen Turnpike
Ridgefield Park, NJ 07660
info@myivation.com
MADE IN CHINA
IVATION is a trademark of C&A IP Holdings, LLC
©2014 All Rights Reserved