J.Burrows JBPHDHBFBK User manual

JBPHDHBFBK
PROFESSIONAL EXTRA HEAVY DUTY
ERGONOMIC CHAIR
1/9
ASSEMBLY INSTRUCTIONS
Weight capacity: 160kgs
1CTN
This design and instruction booklet is subject to copyright.
www.officeworks.com.au
For spare parts or hardware call [phone] or email [email protected]

15
2/9
Officeworks Ltd. | 236-262 East Boundary Road | Bentleigh East VIC 3165 | AUSTRALIA
• Please check you have all hardware before assembly.
• If you are missing any hardware, please contact Kyvas on [phone] or email
[email protected]
• Please ensure you have the name of the item, required hardware part and quantity.
• Please retain your receipt as proof of purchase to validate your warranty.
.
NOTE
• Do not tighten screws before all screws are in the right place.
• Do not use this product unless all bolts, screws and knobs are firmly secured.
• Check that all bolts, screws and knobs are securely tightened at least every 4 months.
CAUTION
• If parts are missing, broken, damaged or worn stop using the product until all repairs
are made using manufacturer authorised parts.
• Failure to follow these warnings could result in serious injury
WARNING
• CHILDREN MUST BE SUPERVISED.
DANGER
[phone]
Tools Required
CAUTION: Do not use tools other than those required, as this can damage your new item.
Please ensure drill is set to torque 5Nm.
Assembly Video
•To view an assembly video,go to https://www.officeworks.com.au
•Search the product by item code or name:
•Click on the icon to watch the video.

G
(5/16" x 3/4") H(1/4" x 1-1/4")
x 1
x 3 x 6
I
R L
3/9
x1 x1 x1
x1 x1 x5

D
E
F
H
6I
H
6 Pcs
1/4" x 1-1/4" Bolt
used to complete
this step.
C-R C-L
H
I
R L
B
4/9
Key
Note: Turn the Star Base (E) upside down. Push the Castors (F) firmly into hole at the end of each
leg. Turn the Star Base (E) upside and insert Gas Lift (D) into the center hole of Star Base (E).
FRONT
Torque 5 Nm
Only applicable for when using a drill. Set torque to 5Nm.
Do not tighten Screws fully until you have completed assembly.

C-R C-L
B
D
A
Note: Align Back Cushion (A) with Seat Cushion (B) by GENTLY inserting back support plate
into the rear hole of the Seat Plate (B) as shown and TIGHTEN by using 3 x screws (G).
Only applicable for when using a drill. Set torque to 5Nm. Before using your Chair,
ensure that all the Bolts are tightened fully for safety.
Note: Place assembled seat on the Gas Lift (D). Push down firmly until connection is secure.
G
I
G
3 Pcs
5/16" x 3/4" Bolt
used to complete
this step.
5/9
Torque 5 Nm