J.Burrows JBWASHCHBK User manual

Washington HB Chair
This chair has a load rating of 130kg
JBWASHCHBK

4
Assemble Item On A Clean Flat Surface

C-L
B
C-R
J
6
L

C-R C-L
B
D
I
I

A
Note: Align Back Cushion (A) with Seat Cushion (B) by GENTLY inserting back support plate into the
rear hole of the Seat Plate (D) as shown and TIGHTEN by using the knob on the rear right side
of the Seat Plate (D). Check to make sure the knob is loose before this step.
Insert Plastic Stopper (L) into the back support plate as shown. Push the Back Cushion (A) to the
upright position.
Your Washington HB Chair is now complete and ready for use.
IMPORTANT NOTE: Periodically check and re-tighten screws
L
Australia
Officeworks Superstores Pty Ltd 236-262 East Boundary Road East Bentleigh 3165
Before using your Chair, ensure that all the Bolts are tightened fully for safety.
WARNING: please fully tighten the bolt after
you have completed assembly

Chair Tilt
Adjustbale Chair Tension Speed
-Turn continuously to adjust how
quickly chair tilts back & forth.
Note: if adjusting While sitting in chair:
Turn knob left to tighten tension
Turn knob right to loosen tension
Push button whilst moving the arm
up or down. Release button at
desired height.