J-Tech Digital JTD-2860 User manual

JTD-2860 | JTECH-EXC900
Daisy Chain HDMI over Coaxial Extender
J-TECH DIGITAL INC
e-mail: [e-mail]
TEL: [phone]
Sugar land, tx 77478
12803 park one drive
User manual

I. Introduction
The J-Tech Digital JTECH-EXC900 is designed to extend an HDMI
source signal over coaxial cable. With the device’s strong resistance to
interference and excellent image quality, the JTECH-EXC900 can be
used in a wide array of applications including CCTV, extension to
outdoor displays, hospitality, airports and digital signage.
II. Features
•Transmits HDMI signals up to 1640 ft over RG6 | RG7 | RG11
coaxial cable (Belden 1694A w/ 75Ω connectors recommended)
•Supports HDMI resolutions up to 1080p 60Hz
•HDMI 1.4 & HDCP 1.4 Compliant
•Transmitter features local HDMI loop output
•Receiver features daisy chain coaxial output
•No signal loss or latency
•Supports PCM 48kHz audio format

III. Product Interface
①②
③
④⑤
① HDMI In
④ Power Indicator
② HDMI Loop Out
⑤ Coaxial Out
③ DC In
Transmitter

Receiver
① DC In
④ Coaxial In ② PowerIndicator ⑤
Coaxial Loop Out ③ Signal Indicator
⑥ HDMI Out
①
⑤
②
③
④
⑥

RX
RX
RX
IV. Connection Diagram
There are 2 connection modes for JTECH-EXC900.
Mode 1 - Point to Point Connection
Coaxial Cable HDMI Cable
DVD TX RX Monitor
Mode 2 - Daisy Chain Connection
DVD
HDMI Cable Coaxial Cable
Coaxial RX
Cable
RX
HDMI Cable
HDMI Cable
Monitor
Monitor
HDMI Cable
TX
TX
TX

V. Package Contents
1 x JTECH-EXC900 Transmitter
1 x JTECH-EXC900 Receiver
2 x 12VC Power Adapter
1 x User Manual
Notes:
1. This extender set requires both transmitter and receiver to work as intended.
2. One transmitter can feed signal to multiple receivers via daisy chain connection
method and requires the purchase of additional receivers.
3. Please reset or disconnect and reconnect the power adapter of the transmitter unit
if there is no audio at your display.

Warranty
If your product does not work properly because of a defect in materials or
workmanship, J-Tech Digital (referred to as "the warrantor") will, for the length of the
period indicated as below, (Parts (1) Year) which starts with the date of original
purchase ("Limited Warranty period"), at its option either(a) repair your product with
new or refurbished parts, or (b) replace it with a new of a refurbished product. The
decision to repair or replace will be made by the warrantor. During the "Parts"
warranty period, there will be no charge for parts. You must mail-in your product
during the warranty period. This Limited Warranty is extended only to the original
purchaser and only covers product purchased as new. A purchase receipt or other
proof of original purchase date is required for Limited Warranty service.
Maintenance
Clean this unit with a soft, dry cloth. Never use alcohol, paint thinner of benzine to
clean this unit.
Extended Warranty
With the registration of supported J-Tech Digital products, you extend the current
warranty by 6 months. This extension is added to the warranty that starts at the
purchase date of the device supported. Total product warranty with the extended
period will equate to a total of 18 months of warranty from the date of purchase.
For extended warranties to be accepted, all warranty extensions must be claimed
within 30 days of purchasing the eligible J-Tech Digital product. Extensions attempted
to be claimed outside of the 30-day window will not be accepted. Visit
www.jtechdigital.com to register your extended warranty.