Jabra GN9120 Flex User manual

Jabra GN9120 Flex Alcatel With EHS
How to connect my Jabra GN9120 EHS / GN9125 EHS with
Aastra Open Phone 63 and 65
Prerequisites:
Jabra GN9120 EHS or Jabra GN9125 EHS + Jabra 8800-00-93 + Aastra AZ
– adapter
Jabra GN9120 Standard or Jabra GN9125 Standard
In combination with one of the following phones:
Open Phone 63 / 65
System:
Open Com 100 from EHS 5.2
Open Com 1000 from EHS 3.2
Connection:
1. Connect the RJ9 to RJ9 connection cable supplied with the headset, to
the socket marked with the "phone" symbol on the base of the Jabra
GN9120 and the other end to the "handset" socket of the AZ adapter.
2. Now insert the 8-pin RJ45 plug of the Jabra 8800-00-93 connection
cable into the "AUX" socket on the GN 9120 base.
3. Please connect the hollow socket connector to the socket on the AZ
adapter marked with the "bell" symbol and insert the 6-pin modular
plug into the "second handset" socket on the AZ adapter.
EHS setup:
The Jabra GN912x must support and be set up to RHL EHS.
29/06/2021 13:03
https://www.jabra.hk/supportpages/jabra-gn9120/9120-281-11/faq/33fb12af-3bfb-4844-
af54-c755ef74522e
Page 1 of 3

Proceed as follows to check the EHS mode:
1. Place the headset in the base.
2. Press the PLUS and MINUS buttons simultaneously for approx. 6
seconds until the online display on the headset starts to flash.
3. The base will now display to you the EHS currently installed. The online
light indicates "MSH", the pulsating light "RHL", the MUTE light "DHSG"
and the battery display "AEI".
With the PLUS and MINUS buttons, you can now switch between the
different EHS types.
To confirm the EHS has successfully installed, the base automatically
switches back to charge mode after approx. 10 seconds.
Base setup:
Set the phone set-up switch to "A".
29/06/2021 13:03
https://www.jabra.hk/supportpages/jabra-gn9120/9120-281-11/faq/33fb12af-3bfb-4844-
af54-c755ef74522e
Page 2 of 3

Microphone level setup:
Please call someone with the headset. You must now simultaneously press
the PLUS and MINUS buttons on the headset which immediately produces
a signal tone.
You can now increase the microphone volume with PLUS or decrease the
volume with MINUS.
To confirm, a low signal tone sounds in the background after 15 seconds.
The settings are then automatically saved.
Phone setup
In the phone, you must activate "REMOTE HEADSET" from the options
provided.
>Menu > Settings > Peripherals > Add. phone selection > REMOTE
HEADSET
(new setting on the phone: DECT HEADSET)
29/06/2021 13:03
https://www.jabra.hk/supportpages/jabra-gn9120/9120-281-11/faq/33fb12af-3bfb-4844-
af54-c755ef74522e
Page 3 of 3