Jabra GN9330e - USB - Headset User manual

How to connect my Jabra GN9330e with Siemens OpenStage
30, 40, 60, 80
Jabra Link 14201-10
Prerequisite:
Jabra GN9330e + Jabra LINK 14201-10
In combination with one of the following phones:
OpenStage 30 / 40 / 60 / 80
Important:
Please note that Remote Call Control is only supported by the Jabra
GN9330e from version "L" or from date code 9/09.
Connection:
1. Plug the 1-sided end of the DHSG cable marked blue into the socket
marked with a "headset" symbol on your phone.
2. Insert the RJ9 plug into the socket with the "phone" symbol and the
RJ45 plug into the socket on the Jabra GN9330e base marked with
"AUX".
EHS setup:
1. Put the headset in the base and activate "DHSG" mode.
2. Hold down the "phone" button on the base of the Jabra GN9330e for
approx. 6 seconds until the online display (blue LED) on the headset
starts to flash. The current EHS is displayed to you by activating the
speaker controller in the form of the charge display (green LED).
11/05/2021 15:31
https://www.jabra.in/supportpages/jabra-link-14201-10/14201-10/faq/befe42f9-1e0c-
4140-9893-da33b8074349
Page 1 of 3

LEDs from left to right:
LED 1 = RHL
LED 2 = DHSG
LED 3 = AEI
LED 4 = MSH
Now you can switch between the different software modes (LED 1-4) by
using the "volume" up/down controller on the headset. To confirm the
EHS has successfully installed, the base automatically switches back to
charge mode after approx. 15 seconds.
Base setup:
Set the phone set-up switch to "A".
Answer/end calls on the headset:
Once the dial tone signal can be heard in the headset, you can answer the
call by pressing the "Answer/end" button on the headset, while pressing it
again will end the call.
11/05/2021 15:31
https://www.jabra.in/supportpages/jabra-link-14201-10/14201-10/faq/befe42f9-1e0c-
4140-9893-da33b8074349
Page 2 of 3

Phone setup:
Important: For equipment EHS 3.18, the headset operation must be set up
additionally on the phone.
OpenStage 40: Menu > Audio accessories > Headset > Cordless
OpenStage 60/80: Menu> User> Audio> Settings> Headset> Cordless
Important: The dial tone signal in the headset is transmitted only if the
standard ring tones are used on your phone. There is no dial tone signal
transfer for mp3 ring tones.
11/05/2021 15:31
https://www.jabra.in/supportpages/jabra-link-14201-10/14201-10/faq/befe42f9-1e0c-
4140-9893-da33b8074349
Page 3 of 3