Jabra GN9125 Duo User manual

Jabra GN9125 Duo Flex NC
How to connect my Jabra GN9120 EHS / GN9125 EHS with
Alcatel IP Touch 4028, 4038, 4068
Prerequisite:
Jabra GN9120 EHS + Jabra Link 14201-09
Jabra GN9125 EHS + Jabra Link 14201-09
In combination with one of the following phones:
IP Touch 4028
IP Touch 4038
IP Touch 4068
Connection:
Connect the MSH connection cable to the base of the Jabra GN912x EHS
as follows:
2 modular plugs (RJ10+RJ45)
2-sided end: Insert the RJ45 into the socket identified with "AUX" and the
RJ10 into the socket identified with the “phone” symbol on the base.
2-fold Y-coupling end: Insert the 3.5 mm phone jack into the headset
interface and the RJ12 into the bell socket of the phone. The additional
02/11/2021 22:41
https://www.jabra.ca/supportpages/jabra-gn9125/9129-808-215/faq/d8f5ef13-c0f4-4e7a-
99c5-558f443e1d45
Page 1 of 5

socket on the Y coupling remains free in the case of connection to an IP
phone!
Base setup:
The adjustment controller on the base must be set to "A".
EHS setup:
The Jabra GN912x must support and be set up on MSH EHS.
You can check or set it up as follows:
1. Place the headset on the base.
2. Then press the PLUS and MINUS buttons simultaneously for 6 seconds
until the online display on the headset starts to flash.
3. The base will now display to you the EHS currently installed. The online
light indicates "MSH", the pulsating light indicates "RHL", the MUTE
light "DHSG" and the battery display "AEI".
02/11/2021 22:41
https://www.jabra.ca/supportpages/jabra-gn9125/9129-808-215/faq/d8f5ef13-c0f4-4e7a-
99c5-558f443e1d45
Page 2 of 5

4. With the PLUS or MINUS buttons, you can now switch between the
different EHS types
5. To confirm the EHS has successfully installed, the phone automatically
switches back to charge mode after approx. 10 seconds.
Microphone level setup:
1. Please call someone with the headset.
2. You must now simultaneously press the PLUS and MINUS buttons on
the headset which immediately produces a signal tone.
3. You can now increase the microphone volume with PLUS or decrease
the volume with MINUS.
4. To confirm, after approx. 15 seconds a low signal tone sounds in the
02/11/2021 22:41
https://www.jabra.ca/supportpages/jabra-gn9125/9129-808-215/faq/d8f5ef13-c0f4-4e7a-
99c5-558f443e1d45
Page 3 of 5

background. The settings are then automatically saved.
Phone setup with system software 9.xx and higher:
Settings are no longer required for using the headset on the phone. After
correctly adapting the phone plug, a headset symbol must now appear in
the “phone display”. Should the headset symbol not appear, please check
the following settings:
Menu > Settings > Phone > Phone plug > Activate/select headset.
Phone setup with system software below 9.xx:
Important: The "Force Headset" function should not be activated on the
phone, as otherwise it will not be possible to accept external calls!
Menu > Settings > Phone > Phone plug > Force headset OFF
Menu > Settings > Phone > Socket > Activate headset
Dial tone signal transfer / phone setup:
Important: The dial tone signal in the headset is only transmitted if one of
the following call tones has been selected on your phone Standard /
Classic / Cold River / Dooing-Dooing . > Menu > Settings > Dial tone >
Internal / External
In the event that you still do not have a dial tone signal transfer despite
setting the correct ring tone, check the following settings:
Menu > Settings > Phone > Internal/External > other options
No tone, Progressive, Bleep tones > all items must be set to "OFF".
Calls over the headset can be connected/forwarded as follows:
02/11/2021 22:41
https://www.jabra.ca/supportpages/jabra-gn9125/9129-808-215/faq/d8f5ef13-c0f4-4e7a-
99c5-558f443e1d45
Page 4 of 5

Dial phone number > the following now appears in the phone display
"transfer" > now press the appropriate function button next to the phone
display > when connected you must now end the call using the button
identified with the "handset".
02/11/2021 22:41
https://www.jabra.ca/supportpages/jabra-gn9125/9129-808-215/faq/d8f5ef13-c0f4-4e7a-
99c5-558f443e1d45
Page 5 of 5