Follow the Ja ra Bluetooth Hu ’s user manual to set up the device
and connect it to your desk phone. Turn on oth the Ja ra Bluetooth
Hu and iCom, make sure your iCom is sufficiently charged. Place
them next to each other.
Disconnect the handset from your
desk phone ( y unplugging the
handset from the desk handset port).
Connect the handset to the Ja ra
A7010’s handset socket.
Connect the desk phone handset
port to the Ja ra A7010’s desk phone
socket using the supplied connection
cord (desk phone-to-Bluetooth Hu ).
Connect the power supply to your
Ja ra A7010’s power supply socket.
Pairing and connecting iCom with a
Jabra A7010 Bluetooth Hub
iCom Bluetooth Pairing Guides
Jabra A7010
Initiate the pairing process on your iCom y pressing the Bluetooth
pairing utton for a out 2 seconds until the Bluetooth indicator
flashes lue. Your iCom will remain in pairing mode for two minutes
or until the pairing is completed.
Set your Ja ra Bluetooth Hu in pairing mode y pressing and holding
its pairing utton (1). The LED (2) will show a steady lue light and the
Ja ra Bluetooth Hu will search for a headset.
No passkey is required for iCom and the Ja ra Bluetooth Hu to
esta lish a Bluetooth connection. Simply wait until the two devices
have esta lished a Bluetooth connection. When iCom and Ja ra
Bluetooth Hu have paired successfully, the Ja ra Bluetooth Hu ’s LED
(2) will flash lue 10 times.
Your iCom’s Bluetooth indicator will flash slowly, indicating that the
pairing process is completed.
If the headset LED is still solid lue or if the iCom Bluetooth indicator
is still fast flashing after 2 minutes, repeat steps 2 to 4.
For more information a out how to pair and use your Ja ra Bluetooth
Hu , please read the Ja ra Bluetooth Hu User manual.
Important information:
By pressing the pairing utton (1) shortly you can switch etween
the usage of your desk phone headset or iCom. To hear via iCom
pick up the desk phone handset. Press the utton (1) shortly in case
you don't hear the free line signal in your hearing instruments.
If you want to connect iCom to another Bluetooth phone, you have
to disconnect the connection with the Ja ra Hu . The easiest way is
to unplug the power supply of the Ja ra Hu . The phone can then e
used normally, and the pairing with iCom will not get lost. As soon
as you plug the power supply in again (and iCom is not connected to
another phone) iCom will connect automatically to the Ja ra Hu .
햳
햲
V1.00/2008-05/A+W © Phonak AG All rights reserved / page 1/1
