Basic operations
№1. Mode switching
In standby mode, press the power button 5 times, the set smoking time flashes, press the +/- button to set the
desired smoking time, press the power button 1 time to complete the setting. Time setting is not supported while
smoking.
№2. Power Status
To check the current power status, press the power button once. The battery level is displayed on the OLED screen.
№3. Charging
Even before the smoking process, when you press the power button, the battery level will be displayed on the OLED
screen.
During the charge process, the device is not intended for smoking. A full charge state can last about 3 hours. Full
charge is designed to use 35 tobacco sticks.
№4. Overheat protection
When you turn on or use the cleaning function, the device displays too hot (TOO HOT).
Please allow the device to cool for 1 minute, then restart the device.
№5. Self cleaning function
There are two ways to start the cleanup function.
1 way: Press the power button 8 times continuously in standby mode, the device will start automatic cleaning with
one vibration, displaying cleaning (CLEAN) … after 5 seconds and starting the timer, the surface of the heated rod is
automatically cleaned, the device vibrates again when automatic cleaning is performed.
2 way: After 5 tobacco sticks are smoked, the auto-cleaning system displays on the display screen if the device
needs cleaning. At the same time, it vibrates 5 times, meanwhile, press the +/- button to switch Y and N, select Y to
display, PLS REMOVE THE TOBACCO STICK, press the power button to confirm, enter the cleaning state, select N
or no operation within 15 seconds and then return to the main interface. Pay particular attention to removing the
tobacco stick from the socket before cleaning.
After the automatic cleaning is completed, remove the heat insulating cover, clean the coal dust at the bottom of the
heat insulating cover, and from the bottom, install the heat insulated cover back onto the device to continue using.
Precautions
4 page