Jason.L Horizon Workstation User manual

Tools Required: Power screwdriver.
2 persons required for installation
Special Note: Nut inserts are provided. Line up Desktops with nut inserts to
secure legs to underside of desk top. Only the outside legs use the nut inserts.
The middle shared leg uses wood screws only.
ASSEMBLY INSTRUCTIONS
Horizon Workstation
6 Person
Size: 1600mm
Page 1 of 5
Need help!
Call us on
1300 527 665
www.jasonl.com.au
All manuals and user guides at all-guides.com

Screen x3 (1600mm)
Desk legs x8
Desk leg foot insert x16
L-Shaped post bracket x12
Desk top x6 (1600mm x 800mm)
Beams x6
1
2
3
4
5
6
25mm Woodscrews x967
COMPONENTS
SCREWS
Page 2 of 5
Need help!
Call us on
1300 527 665
www.jasonl.com.au
ASSEMBLY INSTRUCTIONS
Horizon Workstation
6 Person
Size: 1600mm
5
1
2
3
4
6
self-tapping screws
for shared legs
nut inserts
for outer legs
All manuals and user guides at all-guides.com

Need help!
Call us on
1300 527 665
www.jasonl.com.au
ASSEMBLY INSTRUCTIONS
Horizon Workstation
6 Person
Size: 1600mm
Attach the top plates to the outside legs.
Page 3 of 5
02
01
Using an Allen key remove top 2 caps from all screens uprights. Bring two
partition towards one another and slide the 2 way connector rod - down
between the two screen uprights.
Build the centre legs without top plate.
03
Use the beams to connect the legs.
04
All manuals and user guides at all-guides.com

Page 4 of 5
Need help!
Call us on
1300 527 665
www.jasonl.com.au
ASSEMBLY INSTRUCTIONS
Horizon Workstation
6 Person
Size: 1600mm
Nut inserts and flat base screws to be used at holes identified with dotted lines.
Wood Screws to be used in centre of desks for middle leg.
Table top representation:
All manuals and user guides at all-guides.com

Page 5 of 5
Need help!
Call us on
1300 527 665
www.jasonl.com.au
ASSEMBLY INSTRUCTIONS
Horizon Workstation
6 Person
Size: 1600mm
07
Under the desktops, use l-shaped panel brackets to secure
the screens to the desktops. Place two brackets in each
side of each screen (12 L-Shaped bracket in total).
Attach outer legs + beams to Desks Top by tightening Screws into nut inserts.
05
Attach middle legs + beams to Desks Top by tightening Screws.
Use woods screws, and ignore nut inserts here.
06
All manuals and user guides at all-guides.com