Jason.L Horizon 4 Person User manual

ASSEMBLY INSTRUCTIONS
Horizon 4 Person
U-Shape Workstations
Tools Required: Power screwdriver.
2 persons required for installation
Special Note: No pre-drilled holes or nut inserts are provided.
Wood screws will be required to be drilled directly into underside of desk top.
Page 1 of 5
Need help!
Call us on
1300 527 665
www.jasonl.com.au

Screens x6
Desk legs x10
Desk leg foot insert x20
Desk top x4
Desk top return x4
Beams x4
Upper plate x10
Rectangle Cover x8
Cantilever Bracket x4
Connector Plate x8
Rod Brackets x4
2 Way connector rod x1
3 Way connector rod x2
Plastic Panel Bracket x8
1
2
3
4
5
6
7
8
9
10
11
12
13
14
25mm Woodscrews x24
M6x12 Cross Screw x36
St5x20 Wood Screw x32
15
16
17
COMPONENTS
SCREWS
Page 2 of 5
Need help!
Call us on
1300 527 665
www.jasonl.com.au
ASSEMBLY INSTRUCTIONS
Horizon 4 Person
U-Shape Workstations
Legs assembly
7
16 9
16
10
17
8
1
13
12
14
2
5
4
6
3

Attach the upper plate to the leg. Screw to the legs using 3x cross screw.
Cover the outer side with provided rectangle cover.
Page 3 of 5
Need help!
Call us on
1300 527 665
www.jasonl.com.au
ASSEMBLY INSTRUCTIONS
Horizon 4 Person
U-Shape Workstations
Use the beams to connect the legs.
02
Attach legs + beams to Desks Top by tightening Screws.
01
03

Return legs assembly
Need help!
Call us on
1300 527 665
www.jasonl.com.au
ASSEMBLY INSTRUCTIONS
Horizon 4 Person
U-Shape Workstations
06
Turn desk over. Attach Connector Plates to Return Top by tightening wood
screws. Using cross screws assemble leg and Cantilever bracket to Return Top.
Join Cantilever bracket to Leg and Upper Plate.
Turn over again. Join the return with the desk.
Use wood screws to secure Connector Plates to Desk.
05
Attach the upper plate to the leg. Screw to the legs using 3x cross screw.
Cover the outer side with provided rectangle cover.
04
Page 4 of 5

Need help!
Call us on
1300 527 665
www.jasonl.com.au
ASSEMBLY INSTRUCTIONS
Horizon 4 Person
U-Shape Workstations
Page 5 of 5
Divider screens assembly
Using an Allen key remove top 2 caps from all
screens uprights. Bring partition towards one
another and slide the 2 and 3 way connectors
rod - down between screens uprights.