Jotto Desk 425-6190 User manual

425-6190
‘07-‘11 Ford Expedition
Installation Instructions
Tools Needed:
Flathead Screwdriver
7mm Nutdriver
1/4” Drive Handle
1/4” Drive Extension (4” and 6”)
1/4” Drive Ratchet
7/32”, 5/16”, 7/16”, 1/4” Drive Sockets
Long Phillips Screwdriver
Use 7mm nutdriver to remove screw
in console.
Gently pry up and remove cup
holders in console using athead
screwdriver, set aside.
Use phillips screwdriver to remove
(4) screws in the back of console to
remove arm rest.
Remove chrome bezel around gear
shift. Gently pry up with athead
screwdriver and remove.
Pull out rubber tray and set aside.

Remove arm rest. Remove 7mm screws on top of
console.
Gently pry out rear console housing...
Remove and set aside. Gently pry up upper glove box
housing and set aside.
Remove 7mm screws (two in front
and two in back)
...and set aside. Gently pry up on cupholder assembly.
Use 7/32” socket to remove (2) rear
screws.
1-866-587-4661

Remove the caps covering (2) 5/16”
bolts located at the bottom front and
rear of the right and left side panels.
Use 5/16” socket to remove the bolts.
Remove (6) 7mm screws, holding
glove box inner housing, and set
aside.
Remove side panels.
Insert the new console housing using
(6) factory 7mm screws...
Remove screws on side of glove box
housing using a 7/32” socket (two on
each side).
Remove side panels.
...and re-install side panels.
1-866-587-4661

Replace (2) screws on each side of
panels, using phillips screwdriver.
Replace the 5/16” bolts (two on left
side and two on right side of the
console side panels and the covers).
Re-install rear of console.
Install complete.
Install new console, secure (4) bolts
then replace rear cupholder, front
cupholder and gear shift bezel.
Jotto Desk® is a patented product and Registered Trademark of Assembled Products™ Corporation. Contour Console™ has design and utility patents. Additional Patents Pending. Specications subject to change without notice. Printed in the USA
425-6190II 01/12