Jotto Desk 425-6193 User manual

Remove all (6) 8mm bolts that secure
OEM cover plate to vehicle (will be
reused)
At dash of OEM cover plate – remove
tab that secures a cable to OEM
cover plate
Remove (2) OEM Trim Panels from
Side of Dash
Slide Rear Mount Plate under OEM
wiring and replace OEM cover plate.
Secure using the 8mm bolts that
were removed earlier
Disconnect (2) 12v outlets and USB/
Line-in plate. Use small at blade
screw driver to remove OEM 12v
outlets and USB/Line-in plate. Set
aside for remounting USB in Jotto
Desk Contour Console
Secure Jotto Desk Dash Mount
Structure into OEM Dash, using the
same hardware removed to take out
the Middle Dash Structure.
Replace OEM Trim Panels, securing
to provided Dash Mount Structure.
425-6193
‘13+ FORD PI Utility
Contour Console
Installation Instructions
continued on back....
Outside of vehicle – secure the Dash
Mount Bracket to the Jotto Desk
Contour Console. Be sure to nger
tighten the bolts to allow adjustability.
Remove Middle/Lower Dash
Structure – by removing 2 (10 mm)
bolts/screws.

Jotto Desk® is a patented product and Registered Trademark of Assembled Products™ Corporation. Contour Console™ has design and utility patents. Additional Patents Pending. Specications subject to change without notice. Printed in the USA
425-6193II 03/12
Be sure the Console is positioned
inside of the Rear Mount Plate tabs.
Adjust Contour Console so that all
mount points match or line up.
Place Jotto Desk Contour Console
into the vehicle dash area…lining up
the Dash Mount Bracket to the Middle
Dash Structure. Loosely secure using
provided hardware.
Secure through the inside of the
contour console to the rear mount
plate using provided hardware and
tighten all mount points.
Mount USB/Line-in plate into Contour
Console. Re-attach the wiring for the
outlets/USB/line-in.