Joy-it COM-ZY12PDG User manual

USB-PD TRIGGER MODULE
COM-ZY12PDG
1. GENERAL INFORMATION
Dear customer,
Thank you for purchasing our product. In the following, we will show you
which things should be noted during the use.
Should you encounter any unexpected problems, do not hesitate to
contact us.
When using the module, make sure to use a suicient cable
cross-section.
To use the module as intended, you need a USB-PD-capable power
supply unit.

2. INTERFACE
The trigger pin on the board has the same function as the button. By set-
ting the pin LOW, pressing the button is simulated.
Ground
VBUS
Trigger pin
CC2
CC1 USB Type-C
Ground
VBUS

3. OPERATION
Connect your USB-PD trigger module to a USB-PD compatible power
supply using the interface explained above. The free solder pads on the
back of the board are used to connect the load. These modules provide
you with dierent voltage modes, which are indicated by the LED.
Colour Voltage mode
■5 V
■9 V
■12 V
■15 V
■20 V
■Maximum possible voltage of
the power supply
■Runs through all modes
(one per second)
To set the modes as default, first plug the board into your power supply
while holding down the button on the board. Now the LED will start
flashing colourfully. Now you can select the desired mode using the
button. Now press and hold the button to confirm your selection. Finally,
disconnect the power supply from the module and then reconnect it so
that the module now starts directly in this mode.

4. SONSTIGE INFORMATIONEN
Our Information and Take-back Obligations according to the
Electrical and Electronic Equipment Act (ElektroG)
Symbol on Electrial and Electronic Products:
This crossed-out bin means that electrical and electronic products do not
belong into the household waste. You must hand over your old appliance
to a registration place. Before you can hand over the old appliance, you
must remove used batteries and replacement batteries which are not
enclosed by the device.
Return Options:
As the end user, you can hand over your old appliance (which has
essentially the same functions as the new one bought with us) free of
charge for disposal with the purchase of a new device.
Small devices, which do not have outer dimensions bigger than 25 cm
can be handed in for disposal independently of the
purchase of a new product in normal household quantities.
1. Possibility of return at our company location during our opening
hours
Simac Electronics Handel GmbH, Pascalstr. 8, D-47506 Neukirchen-Vluyn
2. Possibility of return nearby
We will send you a parcel stamp with which you can send us your old
appliance free of charge. For this possibility, please contact us via e-mail
at [e-mail] or via telephone.
Information about Package:
Please package your old appliance safe for transport. Should you not
have suitable packaging material or you do not want to use your own
material, you can contact us and we will send you an appropriate
package.
5. SUPPORT
If any questions remained open or problems may arise aer your
purchase,we are available by e-mail, telephone and ticket support
system to answer these.
E-Mail: [e-mail]
Ticket-system: http://support.joy-it.net
Telephone: [phone] – 66 (10 - 17 o'clock)
For further information visit our website:
www.joy-it.net
Published: 12.05.2021
www.joy-it.net
SIMAC Electronics GmbH
Pascalstr. 8, 47506 Neukirchen-Vluyn