Judo PROFI-QC Series User manual

Installation and operating instructions
JUDO PROFI-QC
Backwash protective filter DN 125 - 200
Valid for: EU countries and Switzerland
Language: English
Read before use and store!
Installation and operating instructions
JUDO PROFI-QC
Backwash protective filter DN 125 - 200
Valid for: EU countries and Switzerland
Language: English
Read before use and store!

Queries, orders, customer service
JUDO Wasseraufbereitung GmbH
Postfach 380
D-71351 Winnenden
Email: [email protected] • judo.eu
Office address:
JUDO Wasseraufbereitung GmbH
Hohreuschstraße 39 - 41
D-71364 Winnenden
Trademarks:
Trademarks used in this document are the
protected and registered trademarks of the
owners.
© JUDO Wasseraufbereitung GmbH
D-71364 Winnenden
All rights reserved.
Reprinting, even in excerpt form, is only
permitted with special approval.
Dear customers,
Thank you for the confidence you have
shown in us by purchasing this prod-
uct. You have purchased a state-of-the-
art device. It has been carefully checked
prior to delivery. Nevertheless, if diffi-
culties occur, please contact the closest
customer service (see chapter Customer
service).
These installation and operating instruc-
tions are intended for both installers, who
are in charge of installing, maintaining or
repairing the device, and for the operators
of the device.
2 JUDO JPF-QC 1701803 • 2019/11

Contents
Contents
1 Safety..............................................4
1.1 Intended use................................... 4
1.2 Application limits............................. 4
1.3 Safety instructions...........................4
1.4 Symbols used..................................5
1.5 Units used....................................... 6
2 Product information......................6
2.1 Scope of supply.............................. 6
2.2 Function description........................ 6
2.3 Materials used.................................8
3 Installation..................................... 8
3.1 Conditions....................................... 8
3.2 Installation of the device................. 8
3.3 Draining of the backwash
water................................................9
3.4 Commissioning..............................10
4 Operation..................................... 11
4.1 Cleaning of the sieve insert (back-
washing)........................................ 11
4.2 Conversions, changes...................11
4.3 Maintenance, repair,
spare parts.................................... 12
4.4 Temporary removal of the
device............................................ 12
5 Fault..............................................13
6 Servicing...................................... 14
6.1 Cleaning........................................ 14
6.2 Warranty and maintenance........... 14
7 Technical data............................. 15
7.1 Installation dimensions..................16
7.2 Spare parts....................................17
8 Disposal....................................... 19
9 Customer service........................ 20
1701803 • 2019/11 JUDO JPF-QC 3

Safety
1 Safety
These operating instructions must always
be available at the place of use of the
device.
1.1 Intended use
The device is for the
•Filtration
of drinking water in domestic water pip-
ing and for residential, commercial and
industrial use. It removes coarse and fine-
grained particles from the drinking water,
which are larger or equal to the mesh size
of the filter, in order to prevent
•pipe damage caused by corrosion
•malfunctions of fittings or control and
regulating devices caused by foreign
bodies.
The device can be installed in all commer-
cially available drinking water pipes. Both
installation and use of the device are sub-
ject to the applicable national regulations.
INFO_NO_HEADER
Particles that are smaller than the
mesh size of the filter supplied and
materials causing cloudiness cannot
be filtered out of the water.
1.2 Application limits
1.2.1 Water quality
The water to be filtered must comply with
the European Drinking Water Directive.
Before using the device with water that
does not comply with this Directive, it is
essential to consult the manufacturer.
1.2.2 Water pressure
CAUTION
The water pressure must not exceed
10 bar input pressure. The device
must not be installed if the mains
pressure is above 10 bar (even for a
short time)!
Nominal pressure PN 10
Operating pressure 1.5 bar - 10 bar
The water pressure must not fall
below 1.5 bar as otherwise backwashing
can be impaired!
1.2.3 Water and ambient tempera-
ture
The filter is suitable for use in cold drinking
water up to a maximum water and ambient
temperature of 30 °C.
1.3 Safety instructions
1.3.1 Electrical danger
ELECTRO_NO_HEADER
Risk of electric shock
No electrical wiring or equipment that is
not splash-proof may run or be stored
below the device. Electrical devices/
equipment located in the vicinity of the
device must be splash-proof or comply
with the legal regulations for wet rooms.
1.3.2 Warning of property damage
WARNING
Risk of water damage or damage
to property
The device may only be installed by
qualified technical personnel.
The installation room must be dry and
free from frost.
The ambient temperature must not
exceed 30 °C! In higher temperatures
or direct sunlight, material damage may
occur up to and including breakage of
device parts.
4 JUDO JPF-QC 1701803 • 2019/11

Safety
An adequately sized waste water con-
nection (e.g. floor drain) in compliance
with DIN 1986 must be provided.
In order to ensure safe drinking water
hygiene, a free discharge of the waste
water acc. to DIN EN 1717 must be
ensured.
The pipe must be able to safely sup-
port the device (weight: see chapter 7).
If necessary, the pipes must be provided
with additional fastenings or support.
If no bypass valve is installed, a shut-
off valve must be installed upstream of
the unit in order to interrupt the water
supply during installation, maintenance,
repair or malfunction of the device.
Only operate the device in a technically
faultless condition:
•Check for damage prior to installa-
tion.
•Immediately have any malfunctions in
operation rectified by qualified tech-
nical personnel.
Persons who, due to their physical, sen-
sory or mental abilities or their inexperi-
ence or lack of knowledge, are unable to
operate the device safely may not oper-
ate it without supervision or instruction
from a responsible person.
Regular backwashing of the device is
required to ensure safe drinking water
hygiene (see chapter 4.1.1).
Before carrying out a backwash, ensure
that the wastewater connection is func-
tional.
At the end of the backwashing process,
turn the handwheel until it engages so
that no more backwash water escapes.
Otherwise, water may constantly escape
and cause water damage.
Do not use household cleaning agents
to clean the outside of the device, but
only use clear water to avoid embrittle-
ment of the plastic.
The device may only be repaired by
qualified technical personnel.
Only use original spare parts for repairs.
Before performing work on the device
that goes beyond pure operational use,
the device must be depressurised! If
this is ignored, the result may be uncon-
trolled escape of water resulting in water
damage to the building/home.
If the device is removed due to an inter-
ruption of operation:
•Protect the flange surfaces against
damage to ensure proper sealing.
•Protect the device from dirt so as not
to impair drinking water hygiene.
•Store the device in a frost-free place
to prevent damage caused by freez-
ing water and leakage.
Unauthorised conversions and changes
are forbidden for safety reasons. These
can impair the functioning of the device,
leading to leaks and, in the worse case
scenario, to bursting of the device.
1.4 Symbols used
The safety instructions contained in these
operating instructions are labelled with the
following symbols:
Indication of existing dangers
Warning of electric voltage
User tips and other information
Instructions attached directly to the device,
e.g.:
•Direction of flow (arrow)
•Type label
•Cleaning information
1701803 • 2019/11 JUDO JPF-QC 5