Juniper SRX240 Series User manual

Connecting the SRX240 Services Gateway to the AC Power Source
Figure 1 shows the SRX240 Services Gateway power supply connection.
Figure 1: SRX240 Services Gateway Power Supply Connection
To connect the device to the power supply:
1. Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and
connect the other end of the ESD strap to the ESD point on the rack.
2. Insert the appliance coupler end of a power cord into the appliance inlet on the
power supply faceplate.
3. Insert the plug into an AC power source receptacle.
NOTE: The device must be connected to earth ground during normal operation. The
protective earthing terminal on the rear of the chassis is provided to connect the
device to ground.
CAUTION: We recommend using a surge protector for the power connection.
NOTE: Use the cable tie holder to secure the power cord on to the power supply
point.
Connecting the SRX240 Services Gateway to the AC Power Source ■1

NOTE: We strongly recommend that you use only the 3-pin power cord supplied
with your services gateway. If you are using a 2-pin power cord, then ensure that
your device is adequately grounded using the grounding point available on back
panel of chassis.
Related Topics ■Installing the SRX240 Services Gateway
■Required Tools and Parts for Installing and Maintaining the SRX240 Services
Gateway
■Connecting and Organizing Interface Cables to the SRX240 Services Gateway
■Grounding the SRX240 Services Gateway
■Powering On and Powering Off the SRX240 Services Gateway
Published: 2010-05-03
2■Connecting the SRX240 Services Gateway to the AC Power Source