Juniper SRX5600 User manual

The new network is here.
Juniper Networks Sales Education
© 2010 Juniper Networks, Inc. All rights reserved. www.juniper.net | 1
CONFIDENTIAL FSSSRX5800

S
RX5600 Services Gateway
Installation and Initial
Configuration
Introduction
© 2010 Juniper Networks, Inc. All rights reserved. | www.juniper.net | Proprietary and Confidential

© 2010 Juniper Networks, Inc. All rights reserved. www.juniper.net | 3
CONFIDENTIAL FSSSRX5800

SRX5600 Services Gatewa
y
Installation and Initial
y
Configuration
© 2010 Juniper Networks, Inc. All rights reserved. www.juniper.net | 4
CONFIDENTIAL FSSSRX5800

Course Objectives
On completing this course, you will be able to install or replace the following:
• SRX5800 Services Gateway
•
Switch Control Board (SCB)
•
Switch Control Board (SCB)
• Routing Engine (RE)
• I/O Cards (IOCs)
•
Services Processing Cards (SPCs)
Services Processing Cards (SPCs)
• Small form-factor pluggable transceivers (SFPs)
• 10-Gigabit small form-factor pluggable transceivers (XFPs)
•
Craft interface
Craft interface
• Front and rear fan trays
© 2010 Juniper Networks, Inc. All rights reserved. www.juniper.net | 5
CONFIDENTIAL FSSSRX5800

S
RX5800 Services Gateway
Installation and Initial
Configuration
SRX5800 Services Gateway
Installation
© 2010 Juniper Networks, Inc. All rights reserved. | www.juniper.net | Proprietary and Confidential

Course Objectives
In this section, you will learn to install the Juniper
N t k SRX5800 S i G t
N
e
t
wor
k
s
SRX5800 S
erv
i
ces
G
a
t
eway.
More specifically, after completing this section you
will be able to:
•Describe the SRX5800 Services Gatewa
y
y
•Identify the SRX5800’s components.
•Prepare a site for installation
•Identify the safety procedures to be followed during
itllti
i
ns
t
a
ll
a
ti
on
•List the tools and parts required to install the
SRX5800
•Unpack the SRX5800
•Install the mounting hardware
•Install the SRX5800 with a mechanical lift
•Install the SRX5800 without a mechanical lift
Ctgtdtkblig
•
C
onnec
t
mana
g
emen
t
an
d
ne
t
wor
k
ca
bli
n
g
•Connect AC or DC power
•Connect the console, out-of-band network, and
interface cables
© 2010 Juniper Networks, Inc. All rights reserved. www.juniper.net | 7
CONFIDENTIAL FSSSRX5800
•Perform initial software configuration

SRX5800 Services Gateway Description
•12 slots that can be populated with up to 11 Services Processing Cards (SPCs) and I/O
cards (IOCs) and two Switch Control Boards (SCBs)
•Up to 440 Gigabit Ethernet or 44 10-Gigabit Ethernet ports
•Two types of I/O Card (IOC) interface cards:
• 40-port Gigabit Ethernet IOC with SFP connectors (1000 Mbit copper and fiber only)
4
t 10
Gi bit Eth t IOC ith XFP t
© 2010 Juniper Networks, Inc. All rights reserved. www.juniper.net | 8
CONFIDENTIAL FSSSRX5800
•
4
-por
t 10
–
Gi
ga
bit Eth
erne
t IOC
w
ith XFP
connec
t
ors

SRX5800 Services Gateway Description
SRX5800 connections between IOCs and SCBs are organized in three groups:
• Fabric: Connects the interface cards and provides for packet transport between IOCs.
• Gigabit Ethernet: The control plane of the SRX5800 chassis consists of Gigabit Ethernet
links between Switch Control Boards/Routing Engines and each IOC.
• Management: This group of signals provides for low-level status diagnostic support.
© 2010 Juniper Networks, Inc. All rights reserved. www.juniper.net | 9
CONFIDENTIAL FSSSRX5800

SRX5800 Services Gateway Description
SRX5800 chassis:
• A rigid sheet metal structure that houses all other SRX5800 components
27 75 i (70 49 ) high 17 37 i (44 11 ) id d 23 0 i (58 42 ) d
•
27
.
75 i
n.
(70
.
49
cm
) high
,
17
.
37 i
n.
(44
.
11
cm
)
w
id
e, an
d 23
.
0 i
n.
(58
.
42
cm
) d
eep
• I/O Cards (IOCs):
• Support up to 40xgigE or 4x10gigE
• Combine packet forwarding and Ethernet interfaces on a single board
•
Each PFE consists of one I
chip for Layer 3 processing and one Layer 2 network processor
© 2010 Juniper Networks, Inc. All rights reserved. www.juniper.net | 10
CONFIDENTIAL FSSSRX5800
•
Each PFE consists of one I
-
chip for Layer 3 processing and one Layer 2 network processor
• Interface with power supplies and SCBs