JuTai Comm PR-52 User manual

Shenzhen JuTai Comm Co.,Ltd
Shenzhen JuTai Comm Co.,Ltd
Mingjinhai Industry Park Tangtou Road,shiyan Town Bao’an District Shenzhen,Guangdong Province China.
Web:www.jutairfid.com Tel:[phone] Fax:[phone] E-mail:[email protected]

PR-52 Long Range Parking Reader User Manual
PR-52 2.45GHz&125Mhz Long Range Parking Reader
Packing list
1，Reader 2，User Manual 3，line 4，Mounting bracket &Screw
1 Unit 1 pcs 12PIN 2 Pcs M6*12 inner hexagon screw
U/L Support
Installation：（Unit：mm）
◇Open the reader`s back cover to
setting the activator function.
◇Fix the card reader on the L
bracket(Refer to step-one)
◇Fixing L bracket to the pole with
60MM diameter
◇After power on, reader will make
two “beeps” sound and can see
the red light flashing from the
back of the display.
Notice：
◇Connection Line：signal transportation line and power supply cannot be set in same
pipeline, should be Should be separated not together .
◇Power supply：The reader and locks cannot be installed on the same power supply,
cause when the lock start to work , it will affects the stable status of power
supply which can lead to the reader function failure; Standard configuration
mode for electric lock relay and lock installed on the same power supply,
and the host is to use a separate power supply.
Connection Specification：

Specification
No.
Color
Function
Power Supply
1
Red
DC12V
2
Black
DC 0V
Wigand
output
3
Green
D0
4
Yellow
D1
Loop signal
5
Blue
Loop Relay COM
6
Purple
Loop Relay N.O
Relay Output
7
Light green
Output Relay COM
8
Pink
Output Relay N.O
Low power
signal output
9
Orange
When the card in low
power status, the
indicator of the
reader will flash
10
Gray
Vacancy
11
White
Function Vacancy
12
Brown
Function Vacancy
Dista nce
Function S etting
Dist ance adjust(I n th e air) :Unit :m
0 2 3 4 561 78Location
Distance
9
8765
Set
by PC
◇The parameter can be setting by software of PC：Reader address（1-9 be selectable），
card number uploading time, reading range，Re-reading time default (open/close)（*1），
125Mhz waking up(on/off);buzzer(on/off);
Operations as follows：
Select User –ok--Setting, and select RFID Long Range Reader，Select COMConnect
address(1-31)ok, System will equipped the parameter to the reader automatically.
*2.My PC -Manage-Device Manager-COM Port