JWA Martos 68547 User manual

ASSEMBLY INSTRUCTION
MARTOS COFFEE TABLE
ITEM CODE 68547
Imported by JWA Furniture Pty Ltd, Qld, Brisbane Australia.
For any assistance with assembly or for missing parts please refer to your receipt
1

PRE-ASSEMBLY PREPARATION
Before you start:
1. Choose aclean, level, sd hard surfaces that may
damage the product
2. Take care when li ꢁ ing. Product should be assembled as
point of use
3. Ensure that you have all required coplete assembly
4. Always read the asselly before beginning
5. Keep all hardware parts and packag of small children.
6. Do not over ꢀ ghten the screwsis may damage the threads
7. Assembly is to be carried out by acompetent adult(s) ONLY
8. During assembly, children should bm the product due to
risk to injury.
9. Do not use this item if any components are missing or damaged.
Allow 30 min For 2person Addi ꢀ onal tools required
2

A
E
I
B
F
J
C
G
K
D
H
M7X39mm M15X12mm M8X30mm M3.5X14mm
10pcs 10pcs 18pcs
4pcs
1pcs
6pcs
M5X40mm
10pcs M4X14mm 20pcs
2pcs
L
M4X14mm
2pcs M4x30mm M3.5x14mm
4pcs 1pcs
1
2
3
4
7DRAWER SIDE PANEL
TOP PANEL
8
9
SIDE PANEL
SIDE PANEL
MIDDLE PANEL
BACK PANEL
BOTTOM PANEL
DRAWER SIDE PANEL
DRAWER BACK PANEL
DRAWER BASE
10
11
5
6
DRAWER FRONT
3

STEP 1:
STEP 2:
4

STEP 3:
5

STEP 4:
STEP 5:
6

STEP 6:
STEP 7:
7

STEP 8:
STEP 9:
8
STEP 10:

ASSEMBLY COMPLETE
9

SAFETY BRACKETS
INSTRUCTIONS
1. Attach one Mounting Plate to the wall with the Large Screws. Make sure to
attach the Mounting Plate into a stud. If mounting into brick or masonry you
will need to acquire wall anchors.
2. Attach the second Mounting Plate to the furniture frame with the Short
Screws.
3. Move the furniture to its final position. Thread a Wall Strap through the both
Mounting Plates and tighten until snug. Do not over tighten.
4. Make sure that the Mounting Plates are firmly attached to the wall and
furniture and that the Wall Strap is snug.
HARDWARE
Mounting Plate x 2 Wall Strap x 1 Large Screw x 2 Small Screw x 2
Back side
Wall
L
10