7 USK BL 24242/BL 25280 - 090602
Manual Speed setting
Turn the rotary kno from “MIN” position to “MAX” position to
select the desired speed. The lender runs from low speed to high
speed.
In manual speed setting, the “ice utton”, “smoothie utton” and
“pulse utton” are disa led
• Blender stops running if the current is a ove the limitation and the
pilot light of “pulse utton” flashes, press “pulse utton” again
and the appliance resume working.
• No matter in what mode the lender is working, just lift glass jug
from the motor lock to stop the appliance. To resume operating
the lender, set the speed rotary knob back to “off” position,
replace the jug, select the “On” position and choose the function
or turn the rotary kno to select speed.
HOW TO CLEAN
• Always unplug from outlet efore cleaning.
• For a quick rinsing of the pouring jar (for example etween two
preparations), you can use clear water and switch on your
appliance for a few seconds. In this case, do not use any
detergent.
• For a full cleaning of the pouring jar, remove it from the motor
lock and unscrew the ase of the lade assem ly y turning it
anti-clockwise to disassem le it (this will make the cleaning
easier). Then you can clean the lades and the jar with soapy
water and rinse thoroughly with clear water. Dry efore
assem ling. Therefore you only have to screw the lades support
y turning it clockwise in the ottom of the pouring jar (tighten
vigorously in order to avoid leaks). Attention, do not lose the
sealing ring during this operation.
• You can wipe the motor lock with a soft damp cloth.
• IMPORTANT : the orosilicate jar of your lender is designed to
support sudden temperature variations up to 50°C / 125°F. After
preparing an icy preparation, it is important to avoid cleaning the
jar with very hot water immediately afterwards, or the glass may
shatter. Likewise, after preparing a hot preparation like soup,
please do not rinse with very cold water immediately afterwards.
