Thank you for purchasing this Kam product, we are sure that it will serve you for many years to come.
To optimise it’s performance, please read these instructions carefullytofamiliarise yourself with the basic operations of the unit.
Please retain themfor future reference.This unit has been tested at the factory before being shipped to you. To prevent or reduce
the risk of electrical shock or fire, do not expose the unit to rain or moisture. To prevent afire hazard, do not expose the unit to
any naked flame sources. Unplug this apparatus during lightning storms or if it is unlikely to be used for long periods of time.
When installing the unit, please ensure you leave enough space around the unit for ventilation. Slots and openings in the unit are
provided for ventilation to ensure reliable operation of the product and to protect it from overheating. To prevent fire hazard, the
openings should never be blocked or covered.
The unit is powered by the mains, always handle the power cable by the plug. Never pull out the plug by pulling on the cable.
Never touch the power cable when your hands are wet as this could cause an electric shock. Do not tie a knot inthe cable. The
power cable should be placed such that it is not likely to be stepped on. A damaged power cable can cause a fire or give you an
electrical shock. Check the power cord periodicaly, if you ever find that it is damaged, replace it before using the unit again.
Contact your retailer for a replacement.
The voltage of the available power supply differs according to country or region. Be sure that the power supply voltage of the area
where this unit isto be used meets the requirements of the unit.
Thelightning flash symbol inside a triangle isto alert the usertothe presence high voltage within the unit’s enclosure
that may be of sufficient power to constitute a risk of electrical shock to persons. Caution: to prevent the risk of electric
shock, do not attempt to open the unit. No user-serviceable partsinside. Refer all servicing to qualified service
personnel. The exclamation mark inside a triangle isintended to alert the usertothe presence of important operating
and maintenance instructionsin the literature accompanying the appliance. Please read and pay attention to all safety
warnings on the unit.
Select the installation location of your unit carefully. Avoid placing it in direct sunlight or locations subject to vibration and
excessive dust. Do not use the unit where there are extremes intemperature (below 41ºF / 5ºC or exceeding 95ºF / 35ºC).
Unpacking and safety Please unpack your new product carefully. Your new product should reach you in perfect condition.
Please check that no damage has occurred during transit. If any damage is found, do not operate your unit. Please contact the
retailer you purchased it from immediately. If there is any damage tothe mains cable do not use the device. Always disconnect
the unit from the mains supply when carrying out any cleaning of the unit.
Manufacturer declarations
In compliance with the following requirements: RoHS Directive (2002/95/EU) andWEEE Directive (2002/96/EU).
If this product is ever no longerfunctional please take it to a recycling plant for environmentallyfriendly disposal.
CE declaration of conformity
R&TTE Directive (1999/5/EU), EMC Directive (2004/108/EU), Low Voltage Directive (2006/95/EU).
Before putting the devices into operation, please observe the respective country-specific regulations.
Overhead rigging
Important- the installation must be carried out by qualified service personal only. Improper installation can result in serious
injuries and /or damage to property. Overhead rigging required extensive experience. Working load limits should be respected,
certified installation materials should be used, the installed unit should be inspected regularly for safety.
Make sure the area below the installation place isfree from unwanted persons during rigging, de-rigging and servicing.
Locate the unit in a well ventilated spot, far away from anyflammable materials and/or liquids. The fixture must be fixed at
least 50cmfrom surrounding walls
The device should be installed out of reach of people and outside of areas where persons may walk by or be seated.
Before rigging make sure that the installation area can hold minimum point load of 10 times the device`s weight.
The device should be well fixed; afree swinging mounting is dangerous.
Do not cover any ventilation opening as this may result in overheating
Before first time use, the unit should be inspected for safety. Inspect the unit regularly every year.
