Kamalu M6000 User manual

INSTALLATION INSTRUCTION
Shower Enclosure
K-636
Shower Box M6000 Kamalu

1
directly and you will get a satisfied answer.
NOTE:NOTE:
Please read this installation instruction carefully before installing;
Please check the quantities of the accessories and make sure you have the tools required;
It may also be necessary to consult your tiling supplier about the correct method for drilling your tiles;
If any parts missing/damaged or other problems, please contact your local distributor or our company

Impact drill Level Rubber hammer Glue
Knife
TapePencil
waste pipe
①
Put the water pope of the shower
tray into the drain outlettray into the drain outlet
Concrete
layer
Shower tray
②: place the waste hose into
the waste pipe.
900
900
3
2
2

10
ST4X25
4
3

5
4

6
②
5

7
6

1Press
2Push
8
7

Frame and fixed door installation
9
Ø3 2.
ST4*12 6pc
Decoration
cover
Screw
6pc
8

10
9

11
Seal wall profile flanges to wall on inside vertically.
Seal gap between shower tray to wall on inside.
Seal bottom frame to shower tray horizontally on outside only.
Seal upright profile to wall from shower tray approx. 100mm vertically on outside.
Seal all vertical joints on bottom of frame on outside only.
Allow unit 24hrs to set.
24
10

Maintenance of ShowerEnclosure
1.C leaning
Please use a soft dry,cloth to cleanthe shower enclosure and shower tray.If there isminor dirt,
please use a softcloth or spongedampened in a milddetergent to clean;to remove stubborndirt,
use alcohol.
When cleaning with bath detergent do follow,its instructions and use correctly.
Incorrect using methods will result in bad effects on human body andis easy tomake the product
appear some badsituation.
Do not use following itemsto clean:the acidic,alkalinesolvents,drugs (such as hydrochloric
acid),acetone thinnersand other solventsand scouringpowder,otherwise they will result in bad
effects on human body and is easy tomake the productappear some badsituation.
2.Usage and maintenance of shower room roller
A.Sliding shower door,there aretwo kinds:slider and roller
B.Attention in usage:
1Avoid)over striking the movable door,which may causethe door loose.
2)To clean rails,wheels sliders,regularly,addlubricant (oil orlubricating wax);
3)Adjusting the screws of sliders on a regular basisto ensure the sliders effective carrying and
good sliding to themovable doors.
3.Maintenance of Tempered Glass
1
).
Do not usesharp objects against the surface to avoiddamage;
2).Do not wipe theglass surface withcorrosive liquids to avoid damaging the glossy surface;
3).Do notwipe thesurface with arough material to avoid scratches;
4.Maintenance of Aluminum Frame
A.E lectrostatic paintingproducts (referring tothe white bone blue yellow red,,, ,,purple
and other solidspray type)
1)Prevent direct sunlightand prolonged exposureunder the sunlightwhich will causecolor fading.
2)Do notwipe with corrosive liquidsor materials;
3)Do not use roughmaterial including(toothpaste)for surface cleaning;
4)Do not scratch the surface with sharp objects.
B.Oxidation coloring products (such asgold,silver,matt silver,brush nickelsilver)
Comparing with electrostaticpainting products,oxidation coloris not easyto fade but,duetoits
poorer hardness,please do notwipe with rough materials,especially sharp objects to scratch.
For stain on surface please,wipe using neutral cleanser.
5.Usage and maintenance of Acrylic shower tray.
1
)
Do not usesharp objects against the surface to avoid damage;
2)Do not wipe theacrylic surface with corrosive liquids to avoid damaging the glossysurface;
3)Do notwipe thesurface with rough materials to avoid scratches.
11