K&H Poultry Waterer Unheated Installation guide

K&H Manufacturing, LLC
Colorado Springs, CO
www.khmfg.com | [phone]
Poultry Waterer, Unheated
Care & Instructions
Fill water reservoir with water.
Seat the plastic plug into the hole in cap.
Locate a dry, at area to place base of
waterer.
Set water tank onto base.
Screw cap snugly onto lled water tank.
Be careful not to cross thread.
1
2
4
5
The spike in the center of the base will
dislodge the plug in the cap of the tank
and automatically the ll water base.
6
3
INSTRUCTIONS
CLEANING & CARE
For re-lling, quickly turn over the
water reservoir. Minimal water
discharge will occur if done quickly.
Empty contents from tank, rinse and
rell as necessary.
Hand wash base with mild detergent.
Rinse thoroughly.
Refer to step 1 in the instructions
for use.
For everyday debris free water,
remove the lter ring and gently tap
or rinse it clean.
•
•
•
•
•

K&H Limited Two Year Warranty
Our warranty is as follows: K&H Manufacturing warrants to the original consumer, that this
product will be free of defects and workmanship for a period of two years from the date of
purchase. The manufacturer’s liability hereund
er is limited to replacement of the product. This
warranty is void if the product has been damaged by accident, unreasonable use, neglect, tampering, or other causes not arising from defects in material or workmanship.
To exercise your warranty: If, during the warranty period, your product malfunctions, return it to the place of purchase with your original purchase receipt. If this cannot be done, return the product, postage prepaid, to K&H Manufacturing, with dated proof of purchase or original date receipt. A return authorization number, obtained by calling [phone] must accompany all returns to manufacturer. Please include a note explaining the problem when returning the product.