Kee safety easi-dec HFL010 User manual

HFL010
Issue 01
SAFETY AT THE HIGHEST LEVEL
Hands Free Ladder.
Assembly Instructions
Easi-Dec Access Systems Ltd.,
Merlin House,
Blaydon Road,
Sandy
SG19 1RZ
Tel: +44 ( 0 ) 1767 691812
Fax: +44 ( 0 ) 1767 691802
E-Mail: [email protected]
Internet: www.easi-dec.com
Copyright © 2012 Kee Safety Ltd. All rights reserved.

HFL010
Issue 01
PLEASE BE ADVISED: Before assembling the Hands Free Ladder for the first time, it is highly
recommended that Installers familiarise themselves with the component parts and carry out a test
assembly and disassembly in a safe area away from the point of final installation. All component parts
detailed in the operating instructions must be used in the assembly of the system. Should a piece be
missing or appear defective do not continue to assemble and contact Easi-Dec Immediately.
Step 1 Step 2
FIG 1. Roller wheels
Roll the Ladder up the wall into position with the roller wheels.FIG 1.
Always erect using the 4:1 rule.
Level the Hands Free Ladder adjusting the feet either up or down.
Make sure the Pin and ‘R’ Clips are both replaced.
Step 3 Step 4
Lift the upper Ladder to the desired location and re-seat onto the
rungs with the attached hooks. Make sure the Ladder is positioned
correctly using the 4:1 rule.
Release the rear leg by removing the Pin and ‘R’ Clips and re- fit into
the second hole located on the angle bracket.
Step 5 Step 6
Release the foot allowing it to drop onto the ground and refit the
Pin and ‘R’ clip to the nearest hole.
Always tie the Hands Free Ladder to the building with the Tie-off kit
supplied.

HFL010
Issue 01
Step 7
FIG 2. Ascended the Ladder
Having ascended the Ladder FIG 2. Attach your Harness or safety
belt (Not Supplied) to the underside of the tool tray using a short
(half metre) Lanyard. NOTE: This is designed purely as a restraining
device to prevent the user from over reaching which is a major
cause of Ladder accidents.
Remember
Always fit the Pins and ‘R’ Clips.
Work carefully –Never rush.
Do not use in adverse weather conditions.
Keep the Ladder Level, using the Leg adjustments provided.
Always Tie the Ladder to the building.
Do not attempt to move the Hands Free Ladder with material on the tool tray.
Always erect using the 4:1 rule.
Dismantle: Reverse the above procedure.