KENT KPE216-137 Setup guide

• Use only the voltage specified on the rating
label of the appliance.
• Do not cover or restrict airflow to the
inlet or outlet grilles in any manner as the
appliance may overheat and become a fire
risk.
• Do not cover grilles, block entry or exits of
airflow by placing the appliance against
any surface. Keep all objects at least 1
metre from the front, side and rear of the
appliance.
• Do not locate in areas of high foot traffic,
ensure the power cord and heater are in
view to avoid accidents.
• Do not operate in areas where gasoline,
paint or other flammable liquids are used
or stored.
• This appliance heats up when in use. To
avoid burns, do not touch the front of the
appliance or any of the grilles or vents.
• Before moving the appliance, switch off the
appliance by unplugging it from the wall
and allowing it to cool.
• Do not use the appliance to dry clothes.
• Do not insert or allow foreign objects
or metal utensils into any ventilation or
exhaust openings as this may cause an
electric shock, fire or damage to the
appliance.
• Do not use this appliance in the immediate
surroundings of a bath, a shower or a
swimming pool.
• Do not immerse in liquid or use the
appliance near water as this could create
an electrical shock hazard.
• If the appliance accidentally comes into
contact with water switch off the power
supply and do not touch the appliance.
• Do not operate any appliance with a
damaged cord or plug or after the
appliance malfunctions or has been
Congratulations on your purchase of a Kent
Portable Electric Appliance. Please read the
following instructions carefully before use and
retain for future reference.
BEFORE FIRST USE
• Read and follow all the instructions below
even if you feel you are familiar with the
appliance.
• Remove the packing and make sure that
the appliance is in tact. If in doubt do not
use the appliance and contact the place of
purchase.
• Do not leave packaging materials such as
bags and staples within reach of children.
• Dispose of packaging carefully and with
consideration for the environment.
• It is ideal to retain the appliance carton for
seasonal storage.
For your convenience record the date you
received the appliance on the warranty page
of these instructions, and attach your proof of
purchase. Retain this information in the event
that a warranty service is required.
NOTE: The rating of this appliance (as
marked on the rating label) is based on
specific loading tests. Normal use or the use
of other recommended attachments may draw
significantly less power.
IMPORTANT SAFETY INFORMATION
When using any electrically powered
appliance, these basic safety precautions
should always be followed.
WARNING: DO NOT COVER in order to
avoid overheating.
To reduce the risk of fire, electrical shock or
injury to persons or property:
• To avoid overheating, keep airflow grilles
clear of dust and hair build up - especially
if you have indoor pets.
1
3840-10/13
OWNERS INSTRUCTION MANUAL
MICA-THERMIC SLIM COLUMN HEATER 1500W
Model No. KPE216-137

• Use this appliance only as described in this
manual.
• Any other use is not recommended by the
manufacturer and may cause fire, electric
shock or injury.
Heater Specifications
Model No.: KPE216-137
Heat Settings: 1000W / 1500W
Rating: 220-240V~, 50Hz
ASSEMBLY INSTRUCTIONS
1. Position the heater carefully upside down.
2. Take two screws and place in each round
hole of foot base and screw in tightly with
a screwdriver.
3. Repeat for other leg.
4. Turn the heater the right way up.
Positioning of the Heater
The heater should only be operated at a
minimum distance of 1 metre from any wall or
other object. Position the air flow in order to
optimize the heating of the room.
OPERATING INSTRUCTIONS
NOTE: When switched on for the first time
a slight odour may be emitted for a few
minutes. This is harmless and occurs with
most appliances as slight traces of dust
or lubricants may have collected during
manufacture.
dropped or damaged in any manner –
in order to avoid a hazard. Return to a
qualified electrical person for service or
repair.
• Do not operate the appliance with wet hands.
• Do not connect the appliance to the mains
voltage until completely assembled and
adjusted.
• This appliance is not intended for outdoor use.
• Always operate upright, on a flat surface only.
• CAUTION: This product is NOT suitable to
be used on long pile carpets.
• Unroll the cord before operating. Operating
with a coiled cord may cause overheating
and fire risk.
• The use of an extension cord with this
appliance is not recommended.
• Do not remove the plug from the power
socket until the appliance has been
switched off.
• Always hold the plug when removing it
from the wall, do not pull the cord.
• Always unplug the appliance when it is not
in use.
• Do not allow the cord to come in to contact
with the appliance surface during operation.
• Do not run the cord under carpeting, mats
or rugs etc. Arrange the cord away from
traffic areas so that it will not be tripped over.
• Do not twist, kink or wrap the cord around
the appliance as this may cause the
insulation to weaken and split.
• This appliance is not intended for use by
persons (including children) with reduced
physical, sensory or mental capabilities,
or lack of experience and knowledge,
unless they have been given supervision or
instruction concerning use of the appliance
by a person responsible for their safety.
• Children should be supervised to ensure that
they do not play with the appliance.
• This appliance is intended for light domestic
use and not for heavy duty commercial or
industrial use.
• The appliance must not be located
immediately below or in front of a socket-
outlet.
• CAUTION: In order to avoid a hazard
due to inadvertent resetting of the thermal
cutout, this appliance must not be supplied
through an external switching device, such
as a timer, or connected to a circuit that is
regularly switched on and off by the utility.
• Never remove the cover of the appliance –
in case of a fault contact a qualified
service person.
2
Thermostat Control
1000W Power
Switch
1500W Power
Switch

Safety Cut-Out Switch
• The heater is fitted with a safety cut-out
switch to switch the heater off if it is
knocked over.
• If the heater is knocked over and the
cut-out switch activates turn the heater off
at the power outlet and take EXTREME
care when standing the heater upright as it
will still be hot.
• Inspect the heater for damage especially to
the heating elements and supply cord.
• If any damage is visible do not operate the
heater.
CLEANING AND CARE
• IMPORTANT: Turn off the heater. Switch
off the power switch and disconnect the
heater from the power socket. Wait for
the heater to be completely cool before
cleaning.
• Vacuum clean air vents and grilles to
remove dust from these areas.
• To remove dust on external surfaces, wipe
the heater with a damp (not wet) lint-
free cloth rinsed in hot soapy water only.
• Do not use any harsh detergent or abrasive
cleaners.
• Do not spray with liquids or submerge in
liquids or water.
• Do not attempt to clean the interior of the
heater.
• Do not attempt to open the heater casing
at any time.
STORAGE
• Store the heater carefully in a dust-free
area during the off season. It is ideal
to store the heater in the carton it was
supplied in. Neatly wind the cord of the
heater to prevent damage to the cord.
• Place the heater on a level surface in a
stable upright position.
• Ensure power switches are in the “O” (OFF)
position and the thermostat is in the “•”
(OFF) position.
• Unwind the power cord and plug your
heater into a power socket (observing the
instructions regarding positioning). Ensure
the voltage on the specification plate is the
same as in your home and the power cord
is lying safely on the ground.
• Switch the heater ON by selecting:
a. Power setting I – 1000W
b. Power setting II – 1500W
• The heater operates when both the
power switch and thermostat function are
activated.
• The red indicator light will turn on and will
be on as long as the plug is in the socket,
and the power is switched on, even if the
appliance does not operate.
Thermostat Function
• Set the desired room temperature by turning
the thermostat dial clockwise to the desired
position. You may adjust the temperature
during use. To turn down the thermostat turn
the dial anti-clockwise.
• To find the ideal thermostat setting for you,
first set the knob to the maximum position.
As soon as the temperature is comfortable,
turn the thermostat down slowly, until the
heater turns off. The heater will keep the
surrounding air at this set temperature
by switching on and off at intervals. The
indicator light lights up when the heater is
on.
• To switch the heater off fully, turn the power
switches to “O” and the thermostat to “•”.
The indicator light will turn off also.
SAFETY FEATURES
Over-Heat Protection
• This heater is protected with an over-heat
protection cut-out facility that switches it off
automatically if it over-heats.
• Overheating can be caused by obstruction
to the air intakes on the back of the heater
or the grill on the front.
• If this occurs please disconnect the heater
from the power socket and allow it to cool
for 30 minutes. Remove any obstruction
and turn the heater back on.
• The heater should operate normally.
Should the problem persist contact your
nearest service centre.
3

Kent®is a registered trademark of Aber, Hamilton, NZ.
www.aber.co.nz
1. Appliances will be free from defects in
material and workmanship under normal
use and service when installed and used in
accordance with all applicable local laws
and regulations.
2. If, during the warranty period, a product
fails to operate properly due to defects in
workmanship or materials, Aber will either,
at its option, repair or replace the product
without charge to the purchaser.
The following circumstances or events
are either deemed to be outside the
scope of the general warranty policy
as set out above, or will invalidate
any warranty claim:
• Normal customer maintenance, including
yearly maintenance, routine maintenance,
lubrication, etc.
• Damage caused by the continued use of a
product after a fault has occurred.
• Accident, Act of God, nature or war, theft,
abuse, misuse, negligence or neglect,
including improper installation.
• Failure to operate or maintain the product in
accordance with the owner’s manual
furnished with the product.
• Any alterations or modifications, including
those affecting the product’s performance,
operation, safety, durability or changes in
its intended use.
• Additional damage to parts or components
due to consented use occurring after any of
the above conditions.
WARRANTY GUIDELINES
• Incorrect installation or commissioning.
• Incorrect electrical installation or fitment to
an inappropriate supply. Any electrical
installation (fitting and wiring of new wall
sockets etc) must be performed by a
qualified electrician.
• The warranty applies only to the goods
supplied and does not cover any other
damage incurred.
• No agent, representative, dealer or
employee of Aber or any other person has
the authority to increase or alter the
obligations of Aber under these warranties.
Proper Maintenance and Operation
The original purchaser must exhibit reasonable
care in the maintenance and operation of the
product as explained in the maintenance
section of the owner/operator’s manual. When
in doubt, the Retailer should be contacted by
the original purchaser for advice.
WARRANTY CLAIM PROCEDURES
Should a product failure occur then the original
dealer should be contacted together with proof
of purchase.
The following will apply to all products from
date of purchase by the original consumer for
use in a normal, domestic situation.
Portable Electric Heaters: 2 years from
date of purchase.
Products used for business purposes will carry
a 90 day warranty.
For full warranty terms & conditions please
refer to our website: www.kent.co.nz.