
KOS-A200
8
MICROCOMPUTER’STERMINAL DESCRIPTION
●USB MAIN MICROCOMPUTER: M30620MCPA28GP (X14: IC1)
Pin No. Pin Name I/O Application Processing Operation Description
1~5 NC O Not used Open output L fixed
6BYTE I External data bus switching input GND connection, fixed to “L” at single chip mode
7CNVSS I Processor mode switching L: PullDown connection, single chip mode
(H: Micro processor mode)
8_MUTE O Audio MUTE control L: MUTE ON, H: MUTE OFF
9NCONot used Open output L fixed
10 _RESET I Reset detection L: RESET, H:NORMAL
11 XOUT O Main clock output X’tal connection
12 VSS - Power supply input GND connection
13 XIN I Main clock input X'tal connection
14 VCC1 - Power supply input BU3.3V connection
15 _NMI I _NMI interrupt input Input H (PullUp) fixed
16 _MSTOP I Standby return interrupt L: STOP, H: STOP cancel (Hi edge)
17 NC O Not used Open output L fixed
18 DSP INT I (DSP) Interruption signal input H: Interruption (Hi edge)
19~22 NC O Not used Open output L fixed
23 E2P SCL I/O (E2P) I2C clock output
24 E2P SDA I/O (E2P) I2C data input/output
25,26 NC O Not used Open output L fixed
27 SCL I (System µ-com) I2C clock input
28 SDA I/O (System µ-com) I2C data input/output
29 DSP TXD O (DSP) Data output for serial data Not used
30 DSP RXD I (DSP) Data input for serial data Not used
31 DSP CLK O (DSP) Clock output for serial data Not used
32
DSP STB (BUSY)
O (DSP) Data strobe signal output (FLASH: BUSY) Not used
33 CS SDATA O (Decoder) Data output for serial data Not used
34 CS BDATA I (Decoder) Data input for serial data Not used
35 CS CLK O (Decoder) Clock output for serial data Not used
36~38 NC O Not used Open output L fixed
39 _EPM O Not used (FLASH: _EPM) Open output L fixed
40 PON D3.3 O D3.3V POWER ON control terminal H:POW ON, L: POW OFF
41 PON A5 O A5.0V POWER ON control terminal H:POW ON, L: POW OFF
42 PON CS1 O CS7410 series 3.3V POWER ON control terminal H: POW ON, L:POW OFF
43 PON CS2 O CS7410 series 1.8V POWER ON control terminal H: POW ON, L:POW OFF
44 _CE O Not used (FLASH: _CE) Open output L fixed
45 _DRV MUTE O Driver MUTE L: STOP, H: MUTE OFF
46,47 NC O Not used Open output L fixed
48 ZERO_M I 0bit MUTE detection H: MUTE ON, L: MUTE OFF
49 DE-EMPHASIS O (DAC) De-emphasis control H: De-emphasis ON, L: OFF