Kettler Cora HUC37310 User manual

Assembly Instructions
Nov 2022
IMPORTANT
PLEASE KEEP THIS BOOKLET FOR FUTURE REFERENCE.
THIS IS IMPORTANT INFORMATION REGARDING THE USE AND
CARE OF YOUR GARDEN FURNITURE.
Cora Dining Table
230 x 100 x 75cm
HUC37310

Parts List
Helpful advice before you begin:
1. We suggest you spend a short time reading through this leaflet and then follow the simple
step by step instructions.
2. Do not discard any of the packaging until you have checked that you have all the parts and
the pack of fittings.
3. Assemble this product on a soft surface.
4. To ensure an easier assembly, we strongly advise that all fittings are only finger tightened
during initial assembly. Only upon completion of the assembly should all fixing points
be fully tightened.
5. Keep fittings out of children’s reach.
6. Do not use any other tools other than those recommended to build this product.
7. Please do not use substitute parts. Use only additional or replacement parts supplied by Kettler.
8. In the unlikely event that this product has missing or damaged parts, please visit our website
www.kettler.co.uk
Do not discard any of the packaging until you have checked
that you have all the parts and the pack of fixings.
ATable Top
DLower Leg Brace
CBrace Rails
1Bolt M6 x 100mm with Nuts
2Bolt M6 x 60mm with Nuts
3Screw M6 x 80mm
4Allen Key
BLeg Frame
x2
x4
x2 x2
x16
x1
x2x1

1
2
Assembly
A
Ensure the table is protected
during assembly to avoid
damage to the surface
2
D
B
C
B
2
1
1
NUT
NUT
NUT
NUT
NUT
NUT
3

Assembly
Finished
3
Attention
Please be aware that painted/varnished surfaces can be damaged by sunscreens. If
the surface of your Kettler leisure furniture comes into contact with sunscreens, the
surface is to be cleaned without delay as described above. Only in this way can lasting
discolouration of the surface by the ingredients of the sunscreen be prevented.

Maintenance and Care Instructions
This product may only be used for its intended
purpose for residential premises. Any other uses
may affect the warranty.
To maintain and lengthen the life of this
product, we recommend the following
regime:
• Kettler furniture is designed to be left
outdoors all year round (excluding cushions).
Cushions should be stored in a dry ambient
temperature when not in use.
• Remove dust regularly with a clean soft brush
and wipe down with a clean damp cloth.
• For tables - Use pads, mats and coasters under
plates, glasses cups etc to protect them from
scratches, spills, stains and heat damage. Wipe
spills immediately to prevent staining.
• Tree sap and bird droppings should be cleaned
off immediately with warm soapy water.
Wood Treatment:
1. Ensure the product is clean. If the product is
clean, you can go straight to stage 2. Cleaner is
only required if it hasn’t been treated for 6-12
months.
Use Hardwood cleaner: First moisten the wood
with water. Apply the HARDWOOD CLEANER
with a soft cloth or sponge. Allow to soak for
3 minutes. Brush the furniture clean with a
scrubbing pad in the direction of the grain.
Rinse furniture well with water.
We recommended that you treat your wooden
furniture with Hardwood cleaner when
required.
2. Use Instant Smoke White Protector for Cora:
Apply a thin layer of Instant Smoke White
Protector with a soft cloth.
Allow to dry for 1 hour and then the wood has
turned smoke white. (If you wish to have a more
intense colour, apply a second thin layer).
We recommended that you treat your
furniture with Instant Smoke White Protector
twice a year (April & October).
3. Hardwood Shield: Apply carefully by dabbing.
Make sure the hardwood is 100% dry and free
of dust. Apply a thin layer of HARDWOOD
SHIELD with a soft cloth. Allow to dry for one
hour and then apply a second thin coat of
HARDWOOD SHIELD. Let the wood dry for 48
hours before exposure to moisture and rain.
We recommended that you treat your
furniture with HARDWOOD SHIELD twice a
year (April & October).
The Kettler after-care range available is
available to purchase from the Kettler website:
www.kettler.co.uk
Failure to comply with the outlined care
instructions will result in the warranty being
invalidated.
• Moving parts such as locking mechanisms,
catches and joints need to be lubricated
(where necessary).
• Storage: During Winter/wetter months store
in a cool, dry and well ventilated location to
prevent excessive shrinkage or expansion of
the wood. Alternatively cover the furniture
with a Kettler tailored cover (where available)
or use a universal breathable cover.
• This product is 100% recyclable. At the
end of the products life, please dispose of
responsibly.
• Colours may vary slightly

• Check all components regularly for correct function, damage and loose connections especially
at the start of the season and at 1-2 month intervals dependent on use.
• Damaged components may endanger your safety or shorten the life of the product. Replace all
damaged parts immediately. Use only spare parts manufactured by Kettler. Should you wish to
purchase spare parts, they can be ordered directly from: www.kettler.co.uk/shop
• Kettler will not be responsible for damaged caused by improper use.
For Your Safety
Attention
• Whilst assembling this product keep out of the reach of children. (Choking hazard –
contains small parts)
• Ensure that your working area is free of possible sources of danger, for example don’t
leave any tools lying around.
• Always dispose of packaging material in such a way that it may not cause any danger.
There is always a risk of suffocation if children play with plastic bags!
• We reserve the right to make changes for technical reasons.
www.kettler.co.uk
Warranty For Home Use
This product is covered by a 3 year
warranty against manufacturing faults.
This warranty applies to domestic use
only. It does not cover commercial use,
mis-use or accidental damage.
To validate your warranty, register
at www.kettler.co.uk and quote
the product code from the front of
this booklet.