Kimo Co 100 User manual

ON : Switch on

OFF : Switch off

Escape : Back to previous screen

1x : ''Hold'' : measurement holding

2x : ''Min/Max'' : display of minimum and

maximum CO value since last request.

3x : ''Min/Max'' : display of minimum and

maximum temperature value since last

request

4x : Back to hold measurement.

''Function'' key

''On / Off'' key

''Select'' key

See ta le elow

''Functions availa le from main screen''

1x Backlight activation

2x Backlight deactivation

''Backlight'' key

CO detector

CO 100

1x ''OK'' : Acces to ''COmax'' function

''OK'' key

Press to activate or deactivate. Validate with

Press to set the alarm 2 threshold then press to increment the 1st digit. Validate

with , set the 2nd digit, validate with , set the 3rd digit then validate with .

Press to set the alarm 1 threshold then press to increment the 1st digit. Validate

with , set the 2nd digit, validate with , set the 3rd digit then validate with .

How to change battery

1. Remove the front part at the ack of the instrument.

2. Remove old attery.

3. Insert the new attery in accordance with proper polarity shown inside the

housing.

4. Replace the front.

To measure COmax

NTang – CO100 - 13/01/11– RCS (24) Périgueux 349 282 095 Non-contractual document – We reserve the right to modify the characteristics of our products without prior notice.

Once returned to KIMO, required waste collection will e assured in the respect of the environment in accordance to 2002/96/CE guidelines relating to WEEE.

● Turn on the detector.

When it starts, the instrument begins the warm-up phase of the sensor. Remaining time of the warm-up of the sensor is displayed

on the screen.

When this pase is completed, the detector displays ambient temperature and CO rate.

To display COmax :

● Press OK.

The minute digit flashes.