
Press to activate or deactivate. If the alarm is activated, press to define the
threshold. Press to increment threshold value and to go to the next number.
Once threshold is defined, stay on the last number at right and press then to go
bac to measurement screen.
Press to activate or deactivate. Validate with
Press to activate or deactivate. Validate with
Press to scroll down units. Validate with
How to change battery
1. Remove the front part at the bac of the instrument
2. Remove old battery
3. Insert the new battery in accordance with proper polarity shown
inside the housing.
4. Replace the front.
Make a measurement
NTang – FG100 - 12/01/11– RCS (24) Périgueux 349 282 095 Non-contractual document – We reserve the right to modify the characteristics of our products without prior notice.
Once returned to KIMO, required waste collection will be assured in the respect of the environment in accordance to 2002/96/CE guidelines relating to WEEE.
Turn on the detector.
When it starts, the instrument beeps and begins the arming up of the sensor. This phase lasts 60 seconds. The screen displays
remaining time of sensor warming up.
- During normal operating, when there is no gas lea age, the instrument emits a regular beep every 2 seconds.
- Otherwise, if a gas lea age has been detected by the instrument, the repetition frequency of the beep will increase as the detected
gas concentration increases and the screen flashes also at the same frequency. When the alarm threshold is exceeded, the beep
becomes continuous.
Automatic
shut-off 2x
Beep 3x
Functions available from main screen
Alarm 4x
Unit 1x