Kingray DW32 User manual

DW32 (44–230/520–860 MHz)
DISTRIBUTION AMPLIFIER
Optimised for both digital and analogue TV signal amplification.
INSTALLATIONMANUAL
Power LED
VHF Gain
Control
-30 dB
Test Point
UHF Gain
Control
Separate or
Combined
Input Link
2.5 mm
DC Plug
VHF Input
VHF/UHF
Input
RF Output
Specialists in TV signal amplification
Thank you for selecting an Australian designed and built
distribution amplifier.
The DW32 is a Free-to-Air distribution amplifier for use in MATV multiple
dwelling applications. It features single or combined VHF/UHF inputs,
separate VHF/UHF gain controls, inbuilt slope, -30 dB test point, local or
remote powering options.
INSTALLATION
The Kingray DW32 is primarily designed for internal applications. However,
in situations where the amplifier needs to be installed externally, it can be
mounted in a MHB001 weather proof housing and remotely powered.
Part No: 310347 Drawing No: 42887-4
2.7 Send your claim to:
Standard Communications Pty Ltd. Unit B, 22-24 College Street, Gladesville,
NSW 2111, Australia. Tel: [phone], Fax: (02)
9816 4722
Email: [e-mail]
2.8 If we determine that your goods are defective, we will pay for the cost of returning
the repaired or replaced goods to you, and reimburse you for your reasonable
expenses of sending your warranty claim to us.
3. What this warranty does not cover
3.1 This warranty will not apply in relation to:
(a) goods modified or altered in any way;
(b) defects and damage caused by use with non Standard Communications
products;
(c) repairs performed other than by our authorised representative;
(d) defects or damage resulting from misuse, accident, impact or neglect;
(e) goods improperly installed or used in a manner contrary to the relevant
instruction manual; or
(f) goods where the serial number has been removed or made illegal.
4. Warranty period
4.1 We provide the following warranty on GME and Kingray products. No repair or
replacement during the warranty period will renew or extend the warranty period
past the period from original date of purchase.
Product Type Warranty Period
Kingray amplifiers, modulators, diplexers and filters,
Kingray plug pack power supplies, Kingray Professional
rack mount products.
3 years

specificAtions
PARAMETER SPECIFICATION
Frequency Range 44-230 / 520-860 MHz
Gain 27 dB – 32 dB (sloped)
Noise Figure < 5 dB
Output Level 112 dBuV DIN45004B @(-60 dB IMR)
Return Loss > 10 dB
Gain Control Range 10 dB VHF, 10 dB UHF (mid stage)
Supply Voltage 12-18 V DC (supplied with PSK12s)
Current Consumption 140 mA
POWERING FEATURES
Option 1 Plug pack (PSK12s, 2.5 m DC socket)
Option 2 To O/P socket (using PIK01)
Operating Temperature -10°C to 50°C
Dimensions 85 x 81 x 27 mm
Weight 144 grams (approx)
Connectors ‘F’ Type
Mount the amplifier with screws onto a vertical surface so the cable
connectors point downwards. There must be free circulation of air around
the amplifier and sufficient space below for the cable connections.
Cable connections
The input/output cable connectors are ‘F’ Type.
Powering options
•  Local Powering: The supply voltage (12-18 V DC) for the DW32 is supplied
by the mains adaptor (PSK06s) which plugs directly into the amplifier
power socket.
•  Line Powering: Achieved via the coaxial cable to the RF output socket by
utilising a PSK12F/PSK18F/PSK06F/PSK06.
Fig. 1
To Distribution
Network
TP Output
DW32
PSK06s
PSK12s/18s
Local Powering
PSK06/06F
PSK12F/18F
Line Powering
Antenna
Input/s
STANDArD cOmmuNIcATIONS cONTrAcT WArrANTy
AgAINST DefecTS
This warranty against defects is given by Standard Communications Pty Ltd ACN
000 346 814 (We, us, our or GME). Our contact details are set out in clause 2.7. This
warranty statement only applies to products purchased in Australia. Please contact
your local GME distributor for products sold outside of Australia. Local distributor
details at www.gme.net.au/export.
1. Consumer guarantees
1.1 Our goods come with guarantees that cannot be excluded under the Australian
Consumer Law. You are entitled to a replacement or refund for a major failure
and for compensation for any other reasonably foreseeable loss or damage.You
are also entitled to have the goods repaired or replaced if the goods fail to be of
acceptable quality and the failure does not amount to a major failure.
1.2 To the extent we are able, we exclude all other conditions, warranties and
obligations which would otherwise be implied.
2. Warranty against defects
2.1 This warranty is in addition to and does not limit, exclude or restrict your
rights under the Competition and Consumer Act 2010 (Australia) or any other
mandatory protection laws that may apply.
2.2 We warrant our goods to be free from defects in materials and workmanship for
the warranty period (see warranty table) from the date of original sale (or another
period we agree to in writing). Subject to our obligations under clause 1.2, we will
at our option, either repair or replace goods which we are satisfied are defective.
We warrant any replacement parts for the remainder of the period of warranty for
the goods into which they are incorporated.
2.3 To the extent permitted by law, our sole liability for breach of a condition,
warranty or other obligation implied by law is limited
(a) in the case of goods we supply, to any one of the following as we decide
–
(i) the replacement of the goods or the supply of equivalent goods;
(ii) the repair of the goods;
(iii) the cost of repairing the goods or of acquiring equivalent goods;
(b) in the case of services we supply, to any one of the following as we decide –
(i) the supplying of the services again;
(ii) the cost of having the services supplied again.
2.4 For repairs outside the warranty period, we warrant our repairs to be free from
defects in materials and workmanship for three months from the date of the
original repair. We agree to re-repair or replace (at our option) any materials or
workmanship which we are satisfied are defective.
2.5 We warrant that we will perform services with reasonable care and skill and agree
to investigate any complaint regarding our services made in good faith. If we are
satisfied that the complaint is justified, and as our sole liability to you under this
warranty (to the extent permitted at law), we agree to supply those services again
at no extra charge to you.
2.6 To make a warranty claim you must before the end of the applicable warranty
period (see warranty table), at your own cost, return the goods you allege are
defective, provide written details of the defect, and give us an original or copy
of the sales invoice or some other evidence showing details of the transaction.