Kingray KMW32FS User manual

Drawing No: 45944-3
Part No: 310551
MODELS KMW32FS, KMD24FS, KMU32FS
SHIELDED F TYPE MASTHEAD AMPLIFIERS
UHF Gain
Control
VHF/UHF or
UHF only Input
VHF Gain
Control
OutputVHF Input Power
on LED
Optimised for both digital and analogue TV signal amplification.
Thank you for selecting an Australian designed F Type masthead amplifier.
• A masthead amplifi er is designed
to amplify low signal levels for both
analogue and digital applications.
• The amplifi er gain should be selected
to suit each individual environment.
• Best mounting location for masthead
unit is on mast within 3 metres of the
antenna.
repaired or replaced if the goods fail to be of
acceptable quality and the failure does not
amount to a major failure.
1.2 To the extent we are able, we exclude all
other conditions, warranties and obligations
which would otherwise be implied.
2. Warranty against defects
2.1 This warranty is in addition to and does
not limit, exclude or restrict your rights
under the Competition and Consumer Act
2010 (Australia) or any other mandatory
protection laws that may apply.
2.2 We warrant our goods to be free from
defects in materials and workmanship for
the warranty period (see warranty table)
from the date of original sale (or another
period we agree to in writing). Subject to our
obligations under clause 1.2, we will at our
option, either repair or replace goods which
we are satisfi ed are defective. We warrant
any replacement parts for the remainder of
the period of warranty for the goods into
which they are incorporated.
2.3 To the extent permitted by law, our sole
liability for breach of a condition, warranty
or other obligation implied by law is limited
(a) in the case of goods we supply, to any
one of the following as we decide -
(i) the replacement of the goods or the
supply of equivalent goods;
(ii) the repair of the goods;
(iii) the cost of repairing the goods or of
acquiring equivalent goods;
(b) in the case of services we supply, to any
one of the following as we decide –
(i) the supplying of the services again;
(ii) the cost of having the services supplied
again.
2.4 For repairs outside the warranty period, we
warrant our repairs to be free from defects
in materials and workmanship for three
months from the date of the original repair.
We agree to re-repair or replace (at our
option) any materials or workmanship which
we are satisfi ed are defective.
2.5 We warrant that we will perform services
with reasonable care and skill and agree
to investigate any complaint regarding
our services made in good faith. If we are
satisfi ed that the complaint is justifi ed,
and as our sole liability to you under this
warranty (to the extent permitted at law),
we agree to supply those services again at
no extra charge to you.
2.6 To make a warranty claim you must before
the end of the applicable warranty period
(see warranty table), at your own cost, return
the goods you allege are defective, provide
written details of the defect, and give us
an original or copy of the sales invoice or
some other evidence showing details of the
transaction.
2.7 Send your claim to:
Standard Communications Pty Ltd.
PO Box 96 Winston Hills, NSW 2153,
Australia.
Tel: [phone] Fax: [phone]
Email: serv[email protected]
2.8 If we determine that your goods are
defective, we will pay for the cost of
returning the repaired or replaced goods to
you, and reimburse you for your reasonable
expenses of sending your warranty claim
to us.
3. What this warranty does not cover
3.1 This warranty will not apply in relation to:
(a) goods modifi ed or altered in any way;
(b) defects and damage caused by use with
non Standard Communications products;
(c) repairs performed other than by our
authorised representative;
(d) defects or damage resulting from misuse,
accident, impact or neglect;
(e) goods improperly installed or used
in a manner contrary to the relevant
instruction manual; or
(f) goods where the serial number has been
removed or made illegal.
4. Warranty period
4.1 We provide the following warranty on
GME and Kingray products. No repair or
replacement during the warranty period will
renew or extend the warranty period past
the period from original date of purchase.
INSTALLATION MANUAL
KM SERIES
Specialists in TV signal amplification
Product Type Warranty
Period
Kingray amplifi ers, modulators,
diplexers and fi lters, Kingray
plug pack power supplies,
Kingray Professional rack
mount products.
3 years
PERTH
P: [phone]
F: [phone]
E: w[email protected]
AUCKLAND
P: [phone]
F: [phone]
E: [e-mail]
For more information call or visit us:
A division of Standard Communications Pty. Ltd.
P.O. Box 96, Winston Hills, NSW 2153, Australia.
45944-3_KM_series_IM.indd 3 20/08/14 3:38 PM

UHF Gain
Control
Combination
VHF/ UHF
Antenna Power Supply
with Injector
To Amplifier
To TV
VHF Gain
Control (KMW32FS/KMD24FS only)
PSK06F
INPUT
14VOLT DC
TV SET OR VCR
PLUG INTO
WALL PLATE
17.5 V AC OR 14 V DC
MASTHEAD AMPLIFIER
SHORT CIRCUIT
PROTECTED FTO FMALE
ADAPTOR
2M CABLE
TV SET OR VCR
PLUG INTO
WALL PLATE
SHORT CIRCUIT
PROTECTED
2M CABLE
17.5 V AC OR 14 V DC
MASTHEAD AMPLIFIER
UHF Gain
Control
Power Supply
with Injector
To Amplifier
VHF Antenna
UHF Antenna
To TV
VHF Gain
Control (KMW32FS/KMD24FS only)
Switch for Combination
or Separate installations
Lid (open)
Flip amplifier 90º
from housing to allow
access to switch
NOTE: There is a small switch located in between the input connectors underneath the
sheilding. This will need to be switched to separate when two antennas are used. The left
input should then be connected to the UHF antenna whilst the right input (middle connector)
should be connected to the VHF antenna.
Connect power supply to wall plate as shown below
PSK06F/08F PSK06/08
All these models are designed for combined or separate antenna inputs
Combined Input
Separate Input
View looking into trhe bottom of the housing
1. Check: There is no earth braid touching
the centre conductor on the coaxial cable.
2. Is there more than one outlet? Check
the splitter box, the power supply must be
connected to the coaxial outlet that feeds
the AC/DC leg of the splitter box to pass
power to the head unit.
(Check if LED is on).
3.
If there is a white line moving through
the picture:
Try a PSK06 14 V DC power
supply.
4. Adjust gain control on amplifi er to achieve
correct signal levels to digital receiver.
TECHNICAL ADVICE
SPECIFICATIONS
This warranty against defects is given by
Standard Communications Pty Ltd ACN 000 346
814 (We, us, our or GME). Our contact details
are set out in clause 2.7. This warranty statement
only applies to products purchased in Australia.
Please contact your local GME distributor
for products sold outside of Australia. Local
distributor details at www.gme.net.au/export.
1. Consumer guarantees
1.1 Our goods come with guarantees that
cannot be excluded under the Australian
Consumer Law. You are entitled to a
replacement or refund for a major failure
and for compensation for any other
reasonably foreseeable loss or damage.
You are also entitled to have the goods
STANDARD COMMUNICATIONS CONTRACT WARRANTY
AGAINST DEFECTS
KMW32FS KMD24FS KMU32FS
FREQUENCY RANGE VHF 44-230 MHz
UHF 520-820 MHz
VHF 174-230 MHz
UHF 520-820 MHz
VHF 44-230 MHz
UHF 520-820 MHz
MAX GAIN VHF 26 dB
UHF 32 dB
VHF 15 dB
UHF 24 dB
VHF -2 dB
UHF 32 dB
NOISE
FIGURE
VHF < 3 dB
UHF < 2.5 dB
VHF < 3 dB
UHF < 2.5 dB
VHF < 3 dB
UHF < 2.5 dB
OUTPUT FIGURE
108 dB
DIN45004B
(-60 dB IMR)
108 dB
DIN45004B
(-60 dB IMR)
108 dB
DIN45004B
(-60 dB IMR)
45944-3_KM_series_IM.indd 6 20/08/14 3:38 PM