Kingray SA162F User manual

INSTALLATION MANUAL
Specialists in Digital TV Distribution Solutions
SA162F & SA164F
2 WAY & 4 WAY SPLITTER AMPLIFIER
The SA162F & SA164F is a low noise splitter amplifier designed to distribute FM radio & digital TV signals.
• Both models are powered directly from the 240 volt mains power.
• A 16dB maximum gain for both models.The SA164F also has 8dB gain control on VHF.
• The LED power indicator allows the user to easily confirm the unit is operational.
Mount the splitter amplifier in a
weatherproof location as close
to the antenna as possible.

2
INSTALLATION
Connect the lead from the antenna to the input of the amplifier and connect the television to one of the
outputs of the amplifier.
Connect the amplifier to the 240 volt mains and ensure the LED is lit.
Adjust the gain control for optimum performance. (SA164F model only)
Note: F Male to Pal Female adaptors have been included to ensure easy installation in the case PAL connections
are being used.
TECHNICAL ADVICE1. Check there is no earth braid touching the centre conductor of the coax.
2. Is there now too much signal causing an overload to the TV?
Adjust the gain control for optimum performance. (SA164F model only)
Bare back cable with a Cable
Stripper or Stanley Knife
Slide on F Connector and crimp or use
a twist-on Connector

3
GME CONTRACT WARRANTY AGAINST DEFECTS
This warranty against defects is given by GME Pty Ltd ACN 000
346 814 (We, us, our or GME). Our contact details are set out
in clause 2.7. This warranty statement only applies to products
purchased in Australia. Please contact your local GME distributor
for products sold outside of Australia. Local distributor details at
www.gme.net.au/export.
1. Consumer guarantees
1.1 Our goods come with guarantees that cannot be excluded
under the Australian Consumer Law. You are entitled
to a replacement or refund for a major failure and for
compensation for any other reasonably foreseeable loss or
damage.You are also entitled to have the goods repaired or
replaced if the goods fail to be of acceptable quality and the
failure does not amount to a major failure.
1.2 To the extent we are able, we exclude all other conditions,
warranties and obligations which would otherwise be implied.
2. Warranty against defects
2.1 This warranty is in addition to and does not limit, exclude or
restrict your rights under the Competition and Consumer Act
2010 (Australia) or any other mandatory protection laws that
may apply.
2.2 We warrant our goods to be free from defects in materials
and workmanship for the warranty period (see warranty table)
from the date of original sale (or another period we agree to
in writing). Subject to our obligations under clause 1.2, we
will at our option, either repair or replace goods which we
are satisfied are defective.We warrant any replacement parts
for the remainder of the period of warranty for the goods into
which they are incorporated.
2.3 To the extent permitted by law, our sole liability for breach
of a condition, warranty or other obligation implied by law is
limited:
(a) in the case of goods we supply, to any one of the following
as we decide -
(i) the replacement of the goods or the supply of equivalent
goods;
(ii) the repair of the goods;
(iii) the cost of repairing the goods or of acquiring equivalent
goods;
(b) in the case of services we supply, to any one of the
following as we decide –
(i) the supplying of the services again;
(ii) the cost of having the services supplied again.
2.4 For repairs outside the warranty period, we warrant our
repairs to be free from defects in materials and workmanship
for three months from the date of the original repair. We
agree to re-repair or replace (at our option) any materials or
workmanship which we are satisfied are defective.
2.5 We warrant that we will perform services with reasonable
care and skill and agree to investigate any complaint
regarding our services made in good faith. If we are satisfied
that the complaint is justified, and as our sole liability to you
under this warranty (to the extent permitted at law), we agree
to supply those services again at no extra charge to you.
2.6 To make a warranty claim you must before the end of the
applicable warranty period (see warranty table), at your
own cost, return the goods you allege are defective, provide
written details of the defect, and give us an original or copy
of the sales invoice or some other evidence showing details of
the transaction.
2.7 Send your claim to:
GME Pty Ltd.
17 Gibbon Rd, Winston Hills, NSW 2153,Australia.
Tel: [phone], Fax: [phone]
Email: [e-mail]
2.8 If we determine that your goods are defective, we will
pay for the cost of returning the repaired or replaced
goods to you, and reimburse you for your reasonable
expenses of sending your warranty claim to us.

4
3. What this warranty does not cover
3.1 This warranty will not apply in relation to:
(a) goods modified or altered in any way;
(b) defects and damage caused by use with non GME
products;
(c) repairs performed other than by our authorised
representative;
(d) defects or damage resulting from misuse, accident,
impact or neglect;
(e) goods improperly installed or used in a manner
contrary to the relevant instruction manual; or
(f) goods where the serial number has been removed
or made illegal.
4. Warranty period
4.1 We provide the following warranty on GME and
Kingray products. No repair or replacement during the
warranty period will renew or extend the warranty
period past the period from original date of purchase.
Product Type Warranty
Period
SA162F & SA164F 3 years
DVB-T/
DVB-T2
HD
Digital Picture
Compatible
4K
ULTRA HD
5G
PROTECTED
ARTWORK SUMMARY
DRAWING # 51843-2
PART # 311137
JIRA REFERENCE GRA-3541
SUPPLIER WK
*
*SA164F only
D/N: 51843-2
P/N: 311137
A division of GME Pty Ltd.
AUS: 1300 463 463. NZ: [phone].
International enquiries email: [email protected]