Kingray MHU24GE User manual

INSTALLATION MANUAL
Drawing No: 42703-4
Part No: 310333
Standard Communications PTY. LTD
warrants this Kingray product to be free
from defects in material and workmanship
for a period of 3 years from the date of
installation and reserves the right to void
warranty if unit was misused, improperly
installed or damaged by claimant.
4
Thank you for selecting an Australian designed and built masthead amplifier.
MODEL MHU24GE
Masthead Amplifier
WARRANTY
•A masthead amplifier is designed to amplify low signal levels for both analogue
and digital applications.
•The amplifier gain should be selected to suit each individual environment.
Mount with polypropylene
securing strap on to mast
or mount to a wall with
the four pre-drilled holes
Best mounting location for
masthead unit is on mast
300 mm to 1 metre below
antenna
Ensure weatherproof strips
remain in place
For maximum
UHF gain
turn control
clockwise
LED
Optimised for both Digital and
Analogue TV Signal Amplification

sPECiFiCations
2 3
*Please note: an F Type Adaptor has been
included in all Kingray F Type Power
Supplies to fit an F Type wall plate.
However, the insert from the wall plate
can be removed and the Power Injector
may be fitted directly with the locking
nut provided.
PSK06F/08F* PSK06/08
Frequency Range VHF: 44 - 230 MHz
UHF: 520 - 820 MHz
Max Gain VHF: -2 dB
UHF: 24 dB
Noise Figure UHF: < 2 dB
Gain Control
Range
UHF: 10 dB
Supply Voltage PSK08/F: 17.5 V AC and
PSK06/F: 14 V DC @ 60 mA
(PSK02 may also be used)
Output Figure 105 dB
DIN45004B @ (-60 dB IMR)
TO
TELEVISION
�
TO AMPLIFIER
�
17.5 VOLTDC
INPUT
Bare back the cable as per diagram,
pushing the earth braid back over
the black sheath. Connect the
earth to the saddle and the centre
conductor to the screw connection.
Bare back cable with
a Cable Stripper or
Stanley Knife.
installation
The amplifier has been designed for seperate VHF and UHF antenna inputs.
tECHniCal aDviCE
1. Check there is no earth braid
touching the centre conductor on
the coaxial cable.
2. Is there more than one outlet?
Check the splitter box, the power supply
must be connected to the coaxial outlet
that feeds the AC/DC leg of the splitter
box to pass power to the head unit.
(Check if LED is on).
3. Is there now too much signal
causing an overload effect to
the VCR?
Try turning down the gain control
on the masthead unit, or select a
smaller dB rating amplifier.
If there is a white line moving
through the picture:
Try a PSK06
14 V DC power supply.
installation ContinuED