Kisi Reader Pro 2 User manual
Installation manual
FCC ID: 2AX80-RPRO
Reade P o 2
List of equipment
/ What is in the bo
Reade P o 2 (1x
Aluminium mounting f ame (1x
Backplate (1x
Hex key (1x)
Secu ity sc ews (1x) (+1 back up)
Wall mount ancho s (2x
Wall mount sc ews (2x
Self tapping sc ews fo metal f ame (2x
Wate p oof kit (1x)
Reade P o 2 (1x) Alluminium
mounting plate (1x) Backplate (1x)
Hex key (1x)
Wall mount ancho s (2x) Wall mount scews (2x)
Secu ity sc ews (1x) + 1 backup
Self tapping sc ew (2x) Wate p oof kit (1x)
Tools needel
x A sc ewd ive /hand d il}
x A #2 Phillips d ive if mounting on mounting bod
x 1 Backplat
x 7/8 inch (22.2mm) d ill bits if mounting on aluminium
p ol
x 1/8 inch (3mm) d ill bit fo pilot holes
Page 1/4
Mounting
instructions
On LV1 Mounting brac e+
- Secure the Bac plate and the Aluminium mounting frame to
the LV1 mounting brac et by using the 2 wall mounted
screws
5 Connect the Reader Pro 2 to the cabling in place
2 Insert the Reader Pro 2 inside the aluminum mounting
frame and then slide up the Reader Pro
Secure the Reader Pro 2 by installing the security screw (hex
ey provided).
Page 2/4
Reader Pro 2
On metalic prolg
- Drill a hole of at least 7/8 inch (22.2mm) of diameter in the
metallic prole
5 Secure the Aluminium mounting frame to the metallic prole
using the 2 self tapping screws
2 Connect the Reader Pro 2 to the cabling in place
Insert the Reader Pro 2 inside the aluminum mounting frame
and then slide the Reader Pro 2 in the upper direction
M Secure the Reader Pro 2 by installing the security screw (hex
ey provided).
Reader Pro 2 Mounting frame Bac plate LV1 Mounting brac et
Reader Pro 2 Mounting frame Aluminium frame
Federal Communication
Commission Interference
Statemen
Contains FCC I :
VPYLB1GC, QOQBGM11
FCC I : 2AX80-RPRO
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance
with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment o and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
a) Reorient or relocate the receiving antenna.
b) Increase the separation between the equipment and
receiver.
c) Connect the equipment to an outlet on a circuit dierent
from that to which the receiver is connected.
d) Consult the dealer or an experienced radio/TV technician
FCC Warning
Radiation Exposure Statement:
Wireless notice:
: Modications not expressly approved by the
manufacturer could void the user's authority to operate the
equipment under FCC Rules
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must
accept any interference, including interference that may
cause undesired operation of the device
This device complies with FCC radiation exposure limits set
forth for an uncontrolled environment and meets the FCC
radio frequency (RF) Exposure Guidelines. This transmitter
must not be co-located or operating in conjunction with any
other antenna or transmitter
The product complies with
the FCC portable RF exposure limit set forth for an
uncontrolled environment and is safe for intended operation
as described in this manual. Further RF exposure reduction
can be achieved if the product is kept as far as possible from
the user body or set the device to lower output power if such
function is availabl
This device complies with FCC radiation
exposure limits set forth for an uncontrolled environment and
meets the FCC radio frequency (RF) Exposure Guidelines.
This transmitter must not be co-located or operating in
conjunction with any other antenna or transmitter
Reader Pro 2
Page 3/4
45 Main Street
11201 Brookly
US
sales@getkisi.co
getkisi.com
Other Kisi IP Access Controllers manuals
