KleenRite 2240 User manual

R
For more information contact:
Toll Free: [phone]
International: [phone]
Fax: [phone]
[email protected]
www.kleenritemfg.com
Quick facts
Capacity:
1 gallon, 35 PSI spotting tank
2 ea. 240 cubic-inch filter bags
Dimensions:
40.5”L x 24”W x 42.5”H when closed
Cleaning Widths:
22”W min, 40” max
Weight: 182 lbs.
Compatibility: water based solutions
only.
Dual HP vacuum motors
Package Includes
25’ permanently attached power cord
Solution line with wand
Vacuum hose with attachments
2 maintenance cleaning brushes
2 restorative cleaning brushes
4 ea. 240 cubic-inch filter bags
The patented escalator cleaning solution for a
new century. Mobility, simple operation & ad-
just-ability for nearly any escalator makes the
2240 a valuable tool in any escalator mainte-
nance program. The 2240 provides addition-
al features such as quart spray bottle holders,
vacuum attachments & on-board storage. Both
restorative & maintenance brushes are includ-
ed standard with every 2240.
US Pat. No. 8555461
2240
Escalator & Moving Sidewalk
Cleaner
SAFETY FIRST
PINCH HAZARD, KEEP HANDS CLEAR OF
BRUSH/VACUUM MECHANISM WHEN
RAISING OR LOWERING HANDLE.
DEPLOY OUTRIGGERS PRIOR TO SETTING
ON ESCALATOR.
DO NOT WEAR LOOSE CLOTHING OR JEW-
ELRY WHEN OPERATING MACHINE. KEEP
HAIR & CLOTHING AWAY FROM MOVING
PARTS.
THE 2240 MUST BE ALIGNED WHEN
SLIDING ONTO ESCALATOR. SLIDING THE
2240 ONTO ESCALATOR AT AN ANGLE
MAY CAUSE BINDING WHICH COULD DAM-
AGE THE ESCALATOR AND/OR THE 2240.
SEE DIAGRAMS BELOW.
NEVER USE POWER CORD FOR CARRYING,
PULLING OR UNPLUGGING THE 2240.
KEEP CORD AWAY FROM MOVING PARTS.
DO NOT MODIFY PLUG OR USE ADAPTER
PLUGS.

1
1. Measure width of escalator.
2. Measure distance from comb strip to
face of escalator kick-plate where esca-
lator grip rail passes through.
3. Extend vacuum pick-up heads and
brushes on both sides of the 2240 un-
til each snaps into a position just under
width measured in step 1.
4. Align the 2240 with escalator and tilt
handle down. DO NOT SET ON ESCALA-
TOR AT THIS TIME.
5. On the side of machine shown above,
find hole in outrigger slide whose dis-
tance from the brush is just over that
measured in step 2. Place outriggers into
these holes.
6. Carefully slide the 2240 onto the
escalator insuring vacuum pick-ups or
brushes don’t rub along escalator kick
panels.
2
3
4
5
6
7
7. Adjust the angle of the vacuum pick-
ups & brushes with the tilt-adjust knob at
the rear, base of the 2240.
8. Raise or lower support rollers as need-
ed to provide approximately 1/16” clear-
ance between tread and vacuum pick-up
heads. Adjustment is made by loosening
roller hardware in the order shown be-
low. Tighten in reverse order.
8
Insure handle
spring bar locks
under base as
shown in photo.
Pull pin to extend
brush.
Depress latch to
extend pick-up.