
www.klevarange.com.au
02 9387 4100
Suite 301 / 209 Oxford St
Bondi Junction NSW 2022 Australia Kleva ® is a registered trademark
of Take Two Marketing and Events Pty Ltd.
• Attach the Bristle Brush attachment, Sponge Applicator, or Polishing Cover to the unit by connecting the back of the chosen
attachment to the gun.
• Depending on the material of the shoe, apply your chosen polish or washing foam to the attachment.
• Press the red power button on the handle of the Rechargeable Washing Wand to operate the unit. From there the attachment will
start to rotate.
• When completed, press the red power button on the handle of the Rechargeable Washing Wand to turn o the unit.
• Remove the used attachment from the rechargeable washing wand and rinse o any dirt and excess washing foam or polish by
using tap water.
• Wring the water out of the attachment and set aside to dry thoroughly before storing away. This will maintain the longevity of the
attachment.
How to use:
• Please ensure the Sponge Applicator is completely dry before applying the Polishing Cover.
• If said attachment is wet prior to use, this will jeopardise the final result.
Sponge Applicator/ Bu Polisher:
• Find a place that is smooth, flat, dry and clean.
• The round face of the hook is attached with a sticker. Therefore, please ensure that the chosen place is convenient for you to locate
the Kleva Clean Sneaks™.
• Remove the paper and stick the hook to the tile, press hard for 10 seconds to ensure the hook stays in please.
• To refrain from the handle detaching and possibly destructing the unit, place the unit into the hook securely and ensure the hook is
clasped tightly around the Rechargeable Washing Wand.
• To lift o, pull the handle upwards so that it comes o the hook.
Holding Hook:
• Insert the USB charging cord into an adaptor. Plug the adaptor into a wall socket and turn the switch on. WARNING: Keep away
from any water or liquids.
• Unscrew the cover at the bottom of the handle and insert the USB charging cord. The indicator light will light up red, meaning that
it is charging.
• When the indicator light is green, this means that the charge has been completed.
• If you want to disconnect the power, remove the power cord plug from the power socket. When disconnecting the power, do not
pull the power cord. WARNING: Keep away from any water or liquids.
• The charging time takes roughly 3 hours to fully charge, however, this can vary.
• It can be used comfortably for 4 hours when fully charged.
WARNING: Do not use damaged power cords or plug operations. Should the product fail or is damaged in any way, do not continue
to operate. If the power cord or product is damaged, please contact the after-sales service department for repair. If the power cord is
damaged, in order to avoid danger, the power cord must be replaced by manufacturers or service agent professionals. Please keep
the power cord away from any water or liquids.
WARNING: Keep away from any water or liquids.
Charging and Precautions: