Klus OLEK User manual

W-KG
fastener
OLEK
conductive
end cap
rod
OLEK xture
W-KG-Z
fastener
OLEK
conductive
end cap
rod
OLEK xture
1) Rod - non-conductive
(drop lead)
2) Rod - conductive driven
power supply
power supply power supply
Tools needed for mounting:
- drill
- allen wrench
- soldering iron
Instruction includes methods of montage:
OLEK - suspended xture mounting instructions
drywall ceiling
1
www.KlusDesign.com
WARNING! All LED strips should be connected to a 12 V or 24 V power supply.
IMPORTANT: The mounting instructions present the basic form of assembly.
More methods and related accessories can be found at www.KlusDesign.com

x2
1. Drill a hole in the extrusion to lead the powering cable.
4. Insert the rods into the holes in the head of the conductive end caps in
tighten them with an allen wrench.
3. Install the cover and both conductive end caps.
cross-section
top view
2. Mount the LED strip in the extrusion and lead the powering cable.
bottom view
cross-section
5. Install the W-KG ceiling fasteners. The fastener installation manual can be
downloaded at www.klusdesign.com. Place the power supplier next to the
fastener and drill the ceiling to lead the cable to it.
6. Mount the xture with rods into the ceiling fasteners. Connect the cable to
the power supplier, leading it through a pre-drilled hole in the ceiling.
OLEK - suspended xture mounting instructions
1. Rod - non-conductive (requires drop lead)
*If fully built xtures are ordered and received from KLUS please skip to #4
2
www.KlusDesign.com

+
-
-+
-+
cross-section side view
bottom view
cross-section
1. Install the cover, LED and both the conductive end caps. The conductive
plates inside the end caps must be soldered each to the separate pole on the
LED stip.
2. Insert the rods into the holes in the head of the conductive end caps in
tighten them with an allen wrench.
3. Install the W-KG-Z ceiling fasteners. The fastener installation manual can be
downloaded at www.klusdesign.com. Connect the cables, each for the single
power pole to the fasteners. The cables should go through a pre-drilled hole just
under the masking cover of the fastener.
4. Mount the xture with rods into the ceiling fasteners. Mind that the
power poles connected to the rods should match the ones connected to the
end caps.
OLEK - suspended xture mounting instructions
2. Rod - conductive driven power supply
*If fully built xtures are ordered and received from KLUS please skip to #3
3
www.KlusDesign.com