2
www.klusdesign.eu
SEPOD mounting instructions
B
A
G
C
D
E
A
B
F
B
4. Connect power and assemble the extrusion (A) with the mounting strip (B).
5. Attach the end caps (D) (E) to the extrusion (A) and the mounting strip (B).
3. Feed the power cable. Insert springs (F) into the extrusion (A). Mount the
LED strip (G) and insert the cover (C). Ilośc sprężyn powinna wynosić: 4 dla
profili 1-metrowych, 6 dla 2-metrowych oraz 8 dla 3-metrowych. Pierwsza i
ostatnia sprężyna powinny znajdować się ok. 10-15 cm od końców profilu.
1. Drill a hole in the mounting strip (B). 2. Feed the power cable and attach the mounting strip (B) to the mounting
surface with screws.
B
A
NOTE! When constructing polygonal fixtures, it is necessary to pay attention
that the hooks of the assembly strip are turned to face outside the built shape.
The last piece of the fixture to be mounted should be with the edges cut at an
angle inwards to the inside of the polygon fixture.
cross-section
hooks of the
mounting strip
bottom view
Powered by TCPDF (www.tcpdf.org)
