Klus STOS-ALU User manual

Parts needed to mount the STOS-ALU extrusion
Cover (C) Clip (E)
End caps (B)
Mounting track
TEST-36 (F)
LED strip (D)
Tools needed for mounting:
- drill
- screwdriver
- screws
Exrusion (A)
TEST-36 mounting instructions
1
www.KlusDesign.com
NOTE! All LED strips must be connected to a 12 V or 24 V power supply.
IMPORTANT: The manual presents the simplest mounting procedure.
More mounting procedures and related accessories can be found at klusdesign.com

F
A
D
C
B
F
F
A
E
1. Drill holes in the mounting track (F). 2. Mount the mounting track (F) using screws and slide the clips (E) into the
mounting track (E).
3. Mount the LED strip (D), insert the cover (C), and then insert the end cap
(B). Feed the power cable.
4. Attach the extrusion (A) to the mounting track (F) and connect power.
TEST-36 mounting instructions
2
www.KlusDesign.com