KMART Mercury User manual

Item No.:42901839
Item Name:
50CM MERCURY BIKE

1 Head tube
5 Head set
11 Front brake
12 Spokes
19 Tyre
21 Front hub
20 Rim
3 Down tube
15 Chain wheel
4 Cable housing
9 Bell 10 Brake lever
8 Grip
7 Stem
6 Handlebar
24 Saddle
27 Reflector
23 Wheel reflector
16 Chain guard
18 Kickstand
13 Chain
17 Pedal
14 Crank
25 Seat post
26 Seat binder
2 Top tube
4 Fork

2

SAFETY PRECAUTIONS
and if not used correctly you may lose control and fall.
If there is front brake,apply the rear brake first, and then apply the front brake. The front brake is strong
3
Always ensure that appropriate footwear is
worn whilst riding this bike. Lace up shoes with rubber soles, never ride barefooted or in sandals, and
ensure that shoelaces are tied and kept out of the way of the wheels and drive system.

4

5
;
Phillips head screwdriver;
adjustable wrench or an 8mm, 10mm, 13mm,14mm
15mm open and box end wrenches;Allen Keys;
A plier with cable cutting ability；Air pump
Keep a Record of Your Bicycle
Each bicyle has a Serial Number stamped into the bottom of the frame. Write down this number to keep it for future reference.Take
a colour photograph of your bicycle, write the Serial number on the back of the photograph and keep it in a safe place. If you keep
a record of the details of your bicycle it will greatly increase the possibility of getting it back should it be lost or stolen.
Remember the advice about LOCKING YOUR BICYCLE. A good quality lock is cheap insurance.
Tools required(Not included in the packing)
6” (15cm)

Tighten them so they do not move and are horizontal. Check the handlebar is in good condition and the ends of the
handlebar are plugged. Check the bell is fitted and working well.
Warning: Handlebar grips and tube end plugs should be replaced if damaged, as bare ends have been know to cause injury.
Please check the condition of grips and bar ends before rdie.
6

7

8

9

10

11

12

13

14

15

16

17