Koala Kare Kidsitter KB888 Guide

®®
Koala Kidsitter®Strap Replacement Instructions
Materials Supplied: Three #8-32 3/8” Phillips Pan Head Machine Screws Tools Required: Phillips Head Screwdriver
1. Position the KidSitter®so that it is in the infant
car seat carrier position. Release the strap from the
buckle on the outside of the high chair leg.
3. On the right leg, loosen the screw securing the
strap to the chair. Discard the old strap and screw.
4. Take the new clip and position it on the left leg so
that slot in the clip aligns with the two holes on the
left leg. The plastic lever should be at the top of the
clip. Using a Phillips Head Screwdriver, secure the clip
to the leg with two of the screws provided.
2. Locate the plastic clip on the left leg and open it so
that the two screws securing it to the leg are exposed.
Using a Phillips Head Screwdriver remove the two
screws. Discard the old clip and screws.
Instructions Continued on the Back

Koala Kare Products A Division of Bobrick
6982 South Quentin St., Centennial, CO 80112-3945
Main 303.539.8300 Toll Free 888.733.3456
Fax [phone]
Koalabear.com
5. Take the new strap and position it on the right leg
so that the hole in the chafe tab aligns with the hole
in the right leg. Use a Phillips Head Screwdriver to
secure the strap to the leg, using the screw provided.
6. Position the KidSitter®so that it is in the High
Chair position. Thread the strap through the hole on
the right side of the seat, across the seat surface
and through the hole on the left side of the seat.
Thread the strap into the clip and push down on the
clip to secure the strap.
7. Clean the KidSitter®and return it to use.
®®
P/N1298 October 2016
Koala Kidsitter®Strap Replacement Instructions