Kogan KA4KOADRONA User manual

4K CAMERA DRONE WITH
OBSTACLE AVOIDANCE
INCLUDING 2 BATTERIES
KA4KOADRONA

2
Safety & Warnings 3
Components 5
Overview 6
Before First Use 8
Operation 11
Wi-Fi UAV App 15
Cleaning & Care 19
Troubleshooting 19

3
Ensure to read all instructions and warnings in this user guide prior to first use. Retain this
user guide for future reference.
•Do not attempt to touch the drone whilst it is operating under any circumstances.
•This drone is not a toy and can be dangerous when used incorrectly. Follow all
instructions while operating. Disassembling or modifying the drone arbitrarily, operating
improperly, or being unfamiliar with this product may lead to an accident and possible
injuries.
•This drone is intended for use by persons aged 14 years or older. It is recommended that
people between 14-18 years operate the drone under adult supervision.
•Ensure the drone is operated in a safe environment.
•It is recommended that you seek the assistance of an experienced drone pilot before
attempting to fly the drone for the first time. Asking a local expert is the best way to
properly assemble, setup, and fly your drone for the first time. It requires a certain
degree of skill to operate and is subject to normal wear and tear.
•Do not fly this drone higher than 120 metres above ground level.
•Do not fly multiple drones simultaneously. Only one drone can be flown at any given
time.
•Do not allow drone to fly out of visible range.
•Ensure the drone is flown at least 30 metres away from any people.
•Do not fly the drone over populated areas (for example, beaches, parks, and event
venues).
•Do not fly drones within 5.5km of airports. Many locations are considered
no-fly zones and you must ensure that you fly in areas that align with local laws and
ordinances.
•Do not record or photograph people without consent.
•Drones are prone to accidents and failures when piloted incorrectly. Operators are
responsible for their actions as well as any damage or injury caused by pilot error and
radio interference.
•This drone is suitable for indoor and outdoor use. Always fly in a place clear of obstacles
and do not fly the drone in a way that would cause hazards to nearby people and
property.
•Do not operate the drone in unsafe conditions and keep clear of heat sources, wires, or
electric power sources.
SAFETY & WARNINGS
WARNING: This drone may need to be registered. Check with your
local authority on the rules for registration.

4
•Do not fly the drone over areas affecting public safety or where there are emergency
operations taking place.
•This drone contains electrical components. Always keep this drone away from water
and other liquids. Exposure to water or moisture in any form can cause this drone to
malfunction resulting in a crash.
•To avoid a potential fire hazard, do not short, reverse the polarity, or puncture batteries.
Battery charging must be done under supervision and in a location out of reach of
children.
•Remove the batteries if they will not be used on the drone for an extended period.
Always dispose of old batteries according to the laws of local environmental authorities.
•Li-Polymer batteries pose higher operational risks compared to other battery types; thus
it is imperative to follow its usage instructions.
•Avoid contact between the battery and metallic objects.
•If there is an increase in battery temperature after operation, cease use immediately
and allow it to cool down. Continuous use of this battery may cause it to expand,
deform, explode, or result in potential fire hazards.
•Do not place heavy objects directly onto the drone or any of its components.
•Images used in this user guide are for reference only.
Battery warnings
•There is a certain risk when using a lithium battery. It may cause fire, bodily injuries, or
property loss. Users must be aware of the risks and take full of responsibility if using the
battery improperly.
•If battery leakage occurs, avoid contact with your eyes or skin. If there is contact, wash
your eyes with water and seek medical care immediately.
•Remove the plug immediately if there is any peculiar smell, noise, or smog.
•Do not use third-party chargers.
•Do not charge a diluted or outworn battery.
•Do not overcharge the battery. Unplug the charger once fully charged.
•Do not charge the battery next to inflammables (for example, carpet, timber floors,
wood furniture, or on the surface of electro-conductive objects).
•Always keep an eye on the battery when charging.
•Do not charge the battery if it has not had sufficient time to cool after use.
•The ambient temperature when charging is between 0–40°C.
•Do not dispose of the battery as rubbish. Familiarise yourself with the local disposal
laws and follow them accordingly.

5
ADrone (x1) B Remote control (x1)
CSpare propellers (x4) DProtective guards (x4) EUSB charging cable (x1)
FBatteries (x2) GScrewdriver (x1) H User guide (x1)
COMPONENTS

6
Drone
1 Propeller 6Power button
2 Obstacle avoidance sensor 7Battery
3 Upper casing 8Arm
4 Camera 9Lower casing
5 Indicator light 10 Motor
OVERVIEW
1
2
3
4
5
6
7
8
9
10

7
Remote control
11 Trim button 16 Capture/record button
12 Speed/headless mode button 17 Flip and roll/return button
13 Left joystick 18 Right joystick
14 Camera angle up button 19 Take-off/land/emergency stop button
15 Camera angle down button 20 Power/obstacle avoidance button
11
12
13
14
15
16
17
18
19
20

8
Remote control
The remote control needs x3 AA batteries (not supplied) to operate.
1. Open the battery cover.
2.Noting the polarity markings (+/–), insert x3 AA batteries into the remote control.
Reattach the battery cover.
Drone
Arms
Open the front arms closest to the camera, then open the back arms.
Notes:
•Do not mix old and new batteries together.
•Do not mix different types of batteries.
BEFORE FIRST USE
Note:
After use, fold the back arms in before folding the front arms.

9
Protective guards
Align the protective guards with the motors on the arms, then attach them by pressing
them into place.
Battery for the drone
The battery must be charged before first use.
1. Remove the lithium battery from the bottom of the drone.
2.Connect the USB charging cable to the charging port on the battery and a power
adapter (not supplied). Plug the power adapter into a socket and switch it on to
charge.
3.After charging, reattach the battery to the drone.
Notes:
•The lights on the battery will illuminate red when charging. The battery
lights will turn off when fully charged.
•A full charge takes around 60–90 minutes.

10
Connecting the signals of the transmitter and receiver
1. Long press the power button on the drone and remote control to turn on the drone
and place it on a level surface. The indicator lights of the transmitter and drone will
be flashing.
2.Push the left joystick to the highest position upwards then push it down to the lowest
position.
3.When you hear two beeps, the indicator lights on the transmitter and drone will
become solidly illuminated. The signal connection is now complete.
Calibrating the transmitter with the drone
This calibration can also be used when the drone is drifting or rotating by itself.
1. Long press the power button to turn on the drone and place it on a level surface.
2.Move and hold the left and right joysticks on the remote control for three seconds in
the positions indicated. The remote control will make a beep and the indicator lights
will flicker.
3.Wait for about three seconds and then the indicator lights will become solidly
illuminated. Calibration is now complete.