Kogan KAALCPROFCA User manual

The KAALCPROFCA Personal Breathalyzer is a hand held
Professional Alcohol Analyzer. It provides stable accurate and
reliable measuring technology.
Please wash your mouth with water and abstain from smoking or
drinking alcohol for at least 10 minutes before use.
· Slide back the battery cover on the back of the device.
· Install 3 x 1.5V alkaline batteries (AAA) into the battery
compartment.
· When battery power is not sufficient enough for testing the battery
indicator will flash. In this circumstance please remove the drained
batteries and replace with a fresh set of batteries immediately.
Power Supply
Measurement

Parts
Blow
No Driving
Unit
Wait Ready Blood alcohol content
above alert level
Battery
Indication

· Press the 'ON' key once to turn on the device. When the machine
is powered on 'ALCO' will be shown on the LCD display. Press
the 'OK' key. The sensor preheating will be activated. 'PH' will
flash three times and begin to count down (from 'PH99' to 'PH90-
00'). 'READY' & “BLOW” will flash alternately with beep tones
when the machine is ready to take a breath sample.
Note: the device will count down for 30 seconds. Please take a
test within this time.
· When ready to take a test the user should blow continuously
through the mouthpiece for about 5-7 seconds. Stop blowing
once you hear a 'beep' tone. If the sampling is successful 'Anly”
will flash upon the display indicating an analysis of the sample
is underway. A reading will then display upon the screen.
If the blowing time is too short the airflow from the user is too
soft or is interrupted 'ERR' will be shown on the LCD. (indicating
an error) The user may press the 'OK' key for a new test. Test
results are displayed on the LCD within 10 seconds.
Press OK KEY
To start
Operation

Note: with the LCD screen displaying the test result, as shown
above, the user may press the 'ON' key to recall the last test
result record.