Kohler 72419IN User manual

72415IN 72421IN
72419IN 72425IN
BEFORE YOU BEGIN
ROUGH-IN DIMENSIONS (in mm)
SHOWERHEAD WITH ARM & ESCUTCHEON
72415IN 72421IN
1220546-IN2 Rev-C
HAND SHOWERWITH METAL HOSE
All information is based on the latest product information available at the time of publication.
kohler Co. reserves the right to make changes in product characteristics, packaging, or
availability at any time without notice.
Please leave these instructions for the consumer. They contain important information.
NOTE:
1. Observe all local plumbing and building codes.
2. Flush the water supply pipes thoroughly to remove any debris.
3. Highest working pressure for handspray & shower head is 0.5MPa (5 bar). If it exceeds
0.5MPa(5 bar), a pressure reducer is needed. The highest and environment temperature is
60 C. Please keep handspray, shower head and shower arm away from heater, or it may
get damaged and cause injury tothe user.
1
4
Kohler India Corporation Pvt. Ltd.
6th Floor. Office Block, Ambiance Island, NH-8
IN
Gurgaon - 122002, Haryana, India
Customer Care No : 1800 103 2244
(Toll Free) & [phone] / 86
Customer Care Email : [email protected]
www.kohler.co.in
INSTALLATION INSTRUCTIONS
1220546-IN2 Rev-C

1210152-**
Showerhead
(only for 72425IN)
1211890-**
Showerhead
(only for 72419IN)
1261228-**
Shower Arm.
1233044-**
Escutcheon
831727-**
Hose assembly
1226888-**
Hand shower
(only for 72415IN)
1226887-**
Hand shower
(only for 72421IN)
72419IN & 72425IN SHOWERHEAD WITH ARM & ESCUTCHEON
1220546-IN2 Rev-C
SERVICE PARTS
72415IN & 72421IN HAND SHOWERWITH METAL HOSE
SHOWER HEAD -
1. Remove the temporary nipple.
2. Slide the escutcheon overthe shower arm(2).
3. Apply tape or sealant to the shower arm, and
install the shower arm into the shower elbow(1).
4. Tight with astrap wrench. Push the escutcheon
against the wall.
5. Flush both water supplies through the shower
arm for one minute before the showerhead is installed.
6. Apply tape or sealant to the exposed end of the
shower arm. Tighten the showerhead(3) with a strap wrench.
OPERATION: For multi mode showerheads & hand shower adjust the lever or
rotate the sprayface to change the spray options.
1
3
2
INSTALLATION
HAND SHOWER -
1. Filter washers(1) provided with shower
hose(2) must be installed ineach endof hose(2).
2. Connect shower hose to handspray(3) and
the watersupply.
2
3
MAINTENANCE: To dislodge debris, rub the nozzles while the water is running.
disconnect the shower head or
handshower and clean the screen washer.
23
**Color code must be specified when ordering
1220546-IN2 Rev-C