Kohler Citrus 12861T User manual

1106578-2-AA/Rev00
安装尺寸安装尺寸
INSTALLATION INSTRUCTIONSINSTALLATION INSTRUCTIONS
安装说明书安装说明书
安装之前安装之前 BEFORE YOU BEGINBEFORE YOU BEGIN
ROUGH-IN DIMENSIONSROUGH-IN DIMENSIONS
所有的资料是按最新出版的产品资料编写而成。科
勒公司保留任何时候不经通知即可改变产品特性、
包装或产品可供类型的权利。
说明书包括重要的安装内容，请把这些资料交给用
户阅读。
All information is based on the latest product information
available at the time of publication. Kohler Co. reserves the right
to make changes in product characteristics, packaging, or
availability at any time without notice.
Please leave these instructions for the consumer. They contain
important information.
HandsprayHandspray
4111T4111T
注意事项：注意事项：
1.一定要先彻底冲洗供水管以清除管道中的杂质。
2.花洒最高工作压力：0.5MPa(5 bar)。水压超过
0.5MPa(5 bar)须安装减压阀。花洒最高工作温度
及环境温度：60 C。请特别注意花洒须远离浴霸，否
则可能损坏花洒，甚至对使用者造成伤害。
NOTESNOTES:
1. Flush the water supply pipes thoroughly to remove debris.
2. The highest working pressure for handspray is 0.5Mpa(5
bars). If it exceeds 0.5Mpa(5 bars), a pressure reducer is
needed. The highest water and environment temperature is 60
C. Please keep handspray away from heater, or maybe
damage it and hurt user.
中国北京市密云县果园西路 2727 号 邮编：101500101500
北京科勒有限公司
安装步骤安装步骤 INSTALLATIONINSTALLATION
35
80
G1/2"
12861T12861T 4111T4111T
如何安装手持花洒如何安装手持花洒 How to Install the HandsprayHow to Install the Handspray
Put the water flow restrictor(3) into the
handspray(4) inlet. Connect handspray to
water supply with shower hose(1, not
provided) and washer(2, not provided).
将限流器（3）塞入花洒（4）进水口，
用花洒软管（1，客户自备）及垫片(2,
客户自备)将花洒连接到水源。
3
2
1
4
12861T12861T 手持花洒手持花洒
手持花洒及托架手持花洒及托架
G1/2"
219
87
33 90
219
87
33 90
11

1106578-2-AA/Rev00 22
把托架盖子(6)与底板(5)撬开。在墙
壁标上安装托架底板位置的记号
(7)。在墙上钻两个洞，以便于安装
胀塞及螺钉。旋紧螺钉，使托架固定
紧贴墙壁。
用托架盖子盖住底板。
Pry between the bracket cover(6) and
base(5) to separate the two parts. Mark
bracket base mounting hole locations(7)
on wall as shown. Drill two holes in the
finished wall as required, for the
installation rawlplugs and screws. Tighten
screws to secure bracket base to the
finished wall.
Replace bracket cover onto bracket base.
如何安装托架如何安装托架 How to Install the ShowerHow to Install the Shower
BracketBracket
将花洒挂在托架上。 Hang the handspray on the shower
bracket.
适用于所有加工处理过的表面：以中性肥皂水清洗
镀层表面，再以干净的软布彻底擦干整个表面。许多
清洁剂，比如氨水、去污粉及洁厕灵等，会对电镀表面
造成伤害，切忌使用。
All Finishes: Clean the finish with mild soap and warm
water. Wipe entire surface completely dry with clean soft
cloth. Many cleaners may contain chemicals, such as
ammonia, chlorine, toilet cleaner etc. which could adversely
affect the finish and are not recommended for cleaning.
零件图零件图 SERVICE PARTSSERVICE PARTS
834759
Shower Bracket
托架
Water Flow Restrictor
880091
限流器
Handspray
1106576
手持花洒 （仅用于 4111T）
有磨损性的清洁用具或清洁剂也不可使用于科勒牌
的水龙头及其配件上。
Do not use abrasive cleaners or solvents on Kohler faucets
and fittings.
清理说明清理说明 CLEANING INSTRUCTIONSCLEANING INSTRUCTIONS
Only for 4111TOnly for 4111T仅对仅对 4111T4111T
Determine a suitable location on the
finished wall to install the bracket.
在墙面上选择合适的位置来安装托
架。
7
6
5