Kohler HARTLAND K-11021T-1S User manual

BEFORE YOU BEGINBEFORE YOU BEGIN
35
Observe all local plumbing and building codes.
Prior to installation, unpack the new sink and inspect it for
damage. Return the sink to its protection carton until you are
ready to install it .
Inspect the waste and supply tubing; replace if necessary.
Cast iron sinks are very heavy. Get help
lifting the sink into place.
For a replacement installation, make sure the existing cutout
is the same size or smaller than the cutout for the new sink.
This sink is not intended for undercounter installation.
Please leave these instructions with the consumer; they
contain important care, cleaning, and warranty information.
PRODUCT WEIGHT: 35KG.
BEFORE YOU INSTALL NEW SINK, PLEASE BUILD
A PROPER STRUCTURE TO SUPPORT THE SINK.
CAUTION: Risk of personal injury or product
damage.
WARNING
RECOMMENDED TOOLS AND MATERIALSRECOMMENDED TOOLS AND MATERIALS
·
·
·
·
·
·
·
·
·
·
·
Sealant
Pencil
Tape Measure
Putty Knife
Sharp Knife or Scissors
Saber Saw or Keyhole Saw
Drill and 13mm Drill Bit
Safety Glasses
Masking Tape
Rags or Paper Toweling
Pipe wrench
·
·
·
·
·
·
·
·
·
·
·
13mm
INSTALLATION INSTRUCTIONS
SR CAST IRON KITCHEN SINK
K-11021T-1S/2S/4S
HARTLAND
ã, 2004
Copyright Kohler China Ltd., 2004
C
1045199-T01-A
368 201419
1

ROUGHING-IN
HARTLAND
102mm 102mm 110mm
45mm
17mm
16mm
810mm
220mm
10.5mm
222.5mm
HARTLAND - 4S
HARTLAND - 2S
INSTALL THE NEW SINKINSTALL THE NEW SINK
Check the desired sink location for
clearance between the backsplash
wall, faucet, fixture, and cabinet.
Position and trace the template on the
countertop as directed on the template.
Drill a 13mm pilot hole on the inside of
the cut line.
Cut out the countertop opening with a
saber or keyhole saw.
Cast iron sinks are very heavy.
Get help lifting the sink.
Temporarily position the sink in the
countertop opening. Verify the fit and
position.
Trace a pencil line, or apply a border of
masking tape around the outside edge
of the sink.
Remove the sink from the countertop
opening.
CAUTION: Risk of personal
injury or property damage.
13mm
2
HARTLAND - 1S
1045199-T01-A
470mm
480
mm
46mm
179mm

IF THE FAUCET AND DRAIN ARE
NOT INSTALLED, INSTALL THEM AT
THIS TIME. BE SURE TO FOLLOW
ALL INSTRUCTIONS PACKED WITH
THE PRODUCT.
Clean the countertop, and carefully
position the sink in the countertop
opening so the sink edges line up with
the pencil line or masking tape border.
Apply a thin , continuous bead of
quality sealant around the sink edges.
Immediately wipe away any excess
sealant, and fill any voids as needed.
Verify that the sink has not moved out
of position.
Allow the sealant to cure at least 30
minutes before proceeding. 30
Sealant
CONNECT SUPPLIES AND
DRAIN ASSEMBLY
·
·
·
·
Connect the faucet supply lines,
according to the manufacture s
instructions.
Connect the drain assembly,
according to the manufacture s
instructions.
Open the faucet valves, and check
for leakage.
Clean up with a non-abrasive
cleaner.
·
·
·
·
Nut
Gasket
Gasket
Nut
IMPORTANT CONSUMER INFORMATIONIMPORTANT CONSUMER INFORMATION
CARE AND CLEANING
·
·
·
·
·
DO NOT use steel wool, abrasive sponge pads, wire
brushes, or metal scrapers to clean a Kohler kitchen sink.
DO NOT use high alkaline or strong acid cleaners.
For stubborn stains such as metal marks, abrasive
cleaners may be used sparingly. Follow cleaner
manufacturer instructions very carefully. Avoid soaking
dishes for long periods of time and refrain from leaving
coffee grounds and tea bags in the sink.
Keep your cast iron sink looking new by rinsing it out
thoroughly after each use.
DO NOT regularly use abrasives on enameled cast iron,
as this will eventually scratch and ruin the surface.
Stubborn paint stains or tar can be removed with
turpentine or paint thinner.
·
·
·
·
·
3
1045199-T01-A
,
,

4
1045199-T01-A
LIMITED ONE-YEAR WARRANTYLIMITED ONE-YEAR WARRANTY
()
()
138
19
200021
Plumbing Fixtures and Fittings Limited
One-year Warranty
Kohler plumbing fixtures and fittings are warranted to be free
of manufacturing defects.
This product is warranted for one year from date of purchase.
Kohler China will be responsible for any problems caused by
manufacturing defects provided with the invoice. Kohler
China will, at its election, repair, replace or make appropriate
adjustment where Kohler China inspection discloses any
such defects occurring in normal usage within one year after
purchase.
Implied warranties including that of merchantability and
fitness for a particular purpose are expressly limited in
duration to the duration of this warranty, Kohler China
disclaims any liability for special, incidental or consequential
damages. Damages to the product caused by misuse, abuse
and installation that is not in accordance with the owner's
manual are not covered by this warranty.
To obtain quick warranty service, please contact your dealer,
or write to Kohler China. (Original sales receipt must be
provided as the proof of purchase.)
Kohler China Investment Company Ltd.
Central Customer Service Center
19/F, Shanghai Square, 138 Huai Hai Road,
Luwan District, Shanghai, PRC
Zip Code: 200021
This is our exclusive written warranty.