Kohler CLICKER DRAIN 7119A User manual

All information is based on the latest product information available at the time of publication. Kohler Co.
reserves the right to make changes in product characteristics, packaging, or availability at any time without
notice.
Please leave these instructions for the consumer. They contain important information.
NOTES:
1. Observe local plumbing codes.
2. Shut off the main water supply.
3. If possible, install this drain before installing the basin.
4. All installations should comply with the relevant requirements of AS/NZS 3500.
1-AN2-%31/05/12
Clicker Drain Kit: 7119A
BEFORE YOU BEGIN
INSTALLATION INSTRUCTIONS
ROUGH-IN DIMENSIONS
Clicker Drain Kit
CLICKER DRAIN
BASIN ACCESSORIES
1
SPARE PARTS
**Color code must be specified when ordering
1101341-AN2-B31/05/12
4
Clicker Drain Kit
CLICKER DRAIN
BASIN ACCESSORIES
Clicker Drain Kit: 7119A
173~185
103
Φ32
Φ41
Φ56
1102888**
Stopper
1102889
Seal
1102892
Piston Kit
1184103
Gasket
1063389
Spacer
1034145**
Adapter
1175618**
Click Drain

INSTALLATION - Slide bar
1.) Ensure all the threaded connections are secure.
2.) Turn on the main water supply and, with the drain closed, check for leaks.
3.) Repair as needed.
INSTALLATION - Checkout
1101341-AN2-B 31/05/2012
21101341-AN2-B 31/05/2012
3
CLEANING INSTRUCTIONS
All Finishes: Clean the finish with mild soap and warm water. Wipe entire surface completely dry with a
clean soft cloth. Many cleaners may contain such chemicals as ammonia, chlorine, toilet chemicals etc. which
could adversely affect the finish and are not recommended for cleaning.
Do not use abrasive cleaners or solvents on Kohler fittings.
1.) Remove the locknut(5), washer(4), gasket(3) and tailpiece(6) from the drain body(7).
2.) Apply tape or sealant to the tailpiece threads and re-thread into the drain body.
3.) Insert the drain body into the basin hole.
4.) Put the rubber gasket (tapered side up), plastic washer and locknut back onto the drain body.
5.) Tighten the locknut to secure the drain onto the basin .
6.) Alternatively plumbers putty can be used instead of the rubber washer(2) if needed.
Note: Do not reposition the drain after installed as the putty or sealant seal may break.
Note: if the drain is installed onto a basin without an overflow hole, use the spacer(8) and gasket(9) as shown.
Note: Select the tailpiece or the adapter(10) according to the trap connection.
12
1
2
7
8
9
10
6
3
4
5
13
14
1.) Turn the stopper(12) counterclockwise to remove.
2.) Take out the seal(13)
3.) Turn the clicker kit counterclockwise to remove.
4.) Replace components as needed.
REPLACING THE CLICKER KIT